Abstract:An accurate estimation of dynamic loads and structural dynamic responses is deemed an indispensable prerequisite for developing trustworthy digital twin (DT) models of dynamically excited structures. Traditional joint load–response estimation (JLRE) algorithms necessitate a full-rank feedthrough matrix, implying that accelerometers are required at all degrees of freedom with input loads. If an unknown input is a bending moment or torque, the rotational acceleration must be measured, which is usually difficult, if not impractical, in real applications. Therefore, the applications of the traditional JLRE in wind turbines (WTs) are rather limited due to the complex excitation mechanism. However, the unified linear input and state estimator (ULISE) algorithm presented in this paper eliminates this constraint. This paper experimentally tested this algorithm on an operating 1:50 scaled WT model. The influences from blade rotation were considered. A comprehensive structural health monitoring (SHM) sensing system was deployed on the WT tower to measure the tower's dynamic responses. A camera system, which integrated digital image correlation (DIC) technology and binocular stereo vision technology, was also adopted. The unknown excitations and unmonitored dynamic responses of the WT tower were estimated simultaneously using the ULISE algorithm. The reconstructed strain and acceleration responses achieved high accuracy, with a normalized root mean square error less than 9%. The blade rotation had a notable impact on the WT tower, primarily manifested as a bending moment whose dominant frequency was corresponding to the blade's rotational speed . Such joint estimations could function as the virtual sensing of unknown inputs and responses in the DT model of the WT tower, which will enable DT-based online remote structural condition assessment and preventive maintenance in the future.

A Digital Twin Based Residual Stress Prediction Method for Turbine Blades

Digital twin modeling for stress prediction of single-crystal turbine blades based on graph convolutional network

Fatigue Crack Propagation Analysis in an Aero-Engine Turbine Disc Using Computational Methods and Spin Test

Research on rapid calculation method of wind turbine blade strain for digital twin

Modeling and experimental study on deformation prediction of thin-walled turbine blades during investment casting process

Numerical Simulation of Thermal Stress During Directional Solidification of Simple Hollow Turbine Blades

An efficient surrogate model for prediction of stress released distortion in large blade machining

Stress Analysis and Deformation Prediction of a Heavy Hydraulic Turbine Blade Casting During Casting and Heat Treatment

Fatigue life prediction of turbine blades with geometric imperfections made of stainless steel

Physics-informed digital twin for wind turbine main bearing fatigue: Quantifying uncertainty in grease degradation

Real-Time Prediction of Probabilistic Crack Growth with a Helicopter Component Digital Twin

Broaching Digital Twin to Predict Forces, Local Overloads, and Surface Topography Irregularities

Development of a digital twin of an onshore wind turbine using monitoring data

Research on main bearing life prediction of direct-drive wind turbine based on digital twin technology

A Quality Prediction and Parameter Optimization Approach for Turbine Blade Multistage Manufacturing

Deformation Prediction of A Heavy Hydro Turbine Blade During the Casting Process with Consideration of Martensitic Transformation

The connection between digital-twin model and physical space for rotating blade: an atomic norm-based BTT undersampled signal reconstruction method

Three-dimensional modeling and reconstructive change of residual stress during machining process of milling, polishing, heat treatment, vibratory finishing, and shot peening of fan blade

A Novel Wind Speed-Sensing Methodology for Wind Turbines Based on Digital Twin Technology

Reliability-based Low-Cycle Fatigue Damage Analysis for Turbine Blade with Thermo-Structural Interaction

Digital twin technology for wind turbine towers based on joint load–response estimation: A laboratory experimental study