Abstract:Ordinary Portland cement (OPC) is the most common curing agent for solidification/stabilization (S/S) of fly ash (FA), however, the treatment is not efficient. This study aims to investigate the S/S of FA with the modified calcium aluminate cement (CAC) as a binder. The modified CAC was obtained by adding sodium dihydrogen phosphate (NaH 2 PO 4 ), an inorganic chemical agent, and sodium diethyl dithiocarbamate (DDTC), an organic chemical agent, into CAC. Toxicity characteristic leaching procedure and unconfined compressive strength (UCS) test were carried out to evaluate the treatment effect of the proposed binder. The sequential extraction procedure (SEP), X-ray diffraction and scanning electron microscopy (SEM) were used to study the chemical speciation , mineralogical characterization and microstructure of the solidified/stabilized FA. The treatment results of pure CAC and OPC showed that the immobilizing efficiency of CAC was much higher than that of OPC. When curing with 10% CAC and 1% DDTC, the leaching concentrations of Cd, Pb and Zn decreased to 0.06, 0.12 and 18.95 mg/L, respectively. With the combination of 10% CAC and 0.5% DDTC + 0.5% NaH 2 PO 4 , the leaching concentrations of Cd, Pb and Zn were 0.12, 0.16 and 10.21 mg/L, respectively. The regulated leaching limits can be met under both of the above combinations. The UCS of the solidified body was 3.02 MPa under the combination of CAC + NaH 2 PO 4 + DDTC, which was much higher than the 1.34 MPa of the CAC + DDTC combination. SEP shows that most unstable forms of Cd, Pb and Zn in FA were converted to stable forms after the treatment by modified CAC. The immobilization mechanisms of the proposed binder included encapsulation of heavy metals and the formation of heavy metal complexes or precipitate. The CAC hydration products, the precipitate and complexes reduced the pores in FA particles and therefore reduced the leachability of heavy metals. This study demonstrated the effectiveness of the proposed modified CAC as a binder for FA treatment. As NaH 2 PO 4 is inexpensive than DDTC, the scheme of CAC + NaH 2 PO 4 + DDTC is recommended.

Solidification/stabilization of highly toxic arsenic-alkali residue by MSWI fly ash-based cementitious material containing Friedel’s salt: Efficiency and mechanism

A Comparative Study on Stabilization of Available As in Highly Contaminated Hazardous Solid Waste.

Stabilization of Heavy Metals in Municipal Solid Waste Circulating Fluidized Bed Incineration Fly Ash by Fusion–hydrothermal Method

Microwave-Assisted Hydrothermal Treatment with Soluble Phosphate Added for Heavy Metals Solidification in MSWI Fly Ash

High-efficient stabilization and solidification of municipal solid waste incineration fly ash by synergy of alkali treatment and supersulfated cement

Solidification/stabilization of municipal solid waste incineration fly ash using uncalcined coal gangue–based alkali-activated cementitious materials

Iron-calcium reinforced solidification of arsenic alkali residue in geopolymer composite: Wide pH stabilization and its mechanism

Coupled microwave hydrothermal dechlorination and geopolymer preparation for the solidification/stabilization of heavy metals and chlorine in municipal solid waste incineration fly ash

Valorization of Municipal Solid Waste Incineration Fly Ash in Low-Carbon Alkali-Activated Materials

Solidification/Stabilization of Waste Incineration Fly Ash by Modified Calcium Aluminate Cement

Stabilisation/solidification of municipal solid waste incineration fly ash by phosphate-enhanced calcium aluminate cement

Improving stabilization/solidification of MSWI fly ash with coal gangue based geopolymer via increasing active calcium content

The cementitious properties of alkali-activated municipal solid waste incineration fly ash-phosphorus slag-secondary aluminum dross matrix composites and the mechanism of solidification of heavy metals

Simultaneous stabilization/solidification of arsenic in acidic wastewater and tin mine tailings with synthetic multiple solid waste base geopolymer

A novel method of calcium dissolution-crystallization-polymerization for stabilization/solidification of MSWI fly ash

Effect of long-term dry–wet circulations on the Solidification/stabilization of Municipal solid waste incineration fly ash using a novel cementitious material

Converting Municipal Solid Waste Incineration Fly Ash and Municipal Sludge into Environmentally Compatible Alkali-Activated Material

Risk assessment for the long-term stability of fly ash-based cementitious material containing arsenic: Dynamic and semidynamic leaching

Co-stabilization/solidification of heavy metals in municipal solid waste incineration fly ash and electrolytic manganese residue based on self-bonding characteristics

Solidification/stabilization and optimization of municipal solid waste incineration fly ash with aluminosilicate solid wastes

Preparation of backfill materials by solidifying municipal solid waste incineration fly ash with slag-based cementitious materials