Abstract:The properties of YMg in B2 structure have been comprehensively analysed using the first-principles plane-wave pseudopotential method. Specifically, the structural, electronic, elastic, vibrational, and optical properties were investigated using the generalized gradient approximation (GGA) method in the context of density functional theory. The Vienna ab initio simulation package (VASP) was utilized for these calculations. The computed lattice parameter (3.803 Å) and bulk modulus (41.33 GPa) are consistent with the earlier data on ambient pressure. The electronic band structure and energy-dependent density of states reveal the metallic nature of the titled compounds. The Born stability requirements confirmed the mechanical stability. The analysis of Pugh's and Poisson's ratios and Cauchy's pressure reveals that YMg is ductile under the pressures in consideration. According to several anisotropy indices, the compound is noticeably anisotropic both in ambient and under pressure. Our investigation includes an analysis of several fundamental mechanical parameters of the material, including the bulk modulus, the pressure derivative of the Zener anisotropy factor, Poisson's ratio, isotropic shear modulus and Young's modulus with a particular focus on their dependence on pressure. We have determined that the elastic constants obtained remain mechanically stable, satisfying the Born Stability conditions even at high pressures of up to 60 GPa. To explore the dynamic stability of YMg, we analysed the material's phonon dispersion curves. The examined compound displays stability under dynamic conditions from 0 GPa to 30 GPa, as evidenced by its positive vibration frequencies. However, this stability is not sustained under higher pressure, as the compound becomes unstable after 30 GPa to 70 GPa. The electronic band structure and density of states diagrams demonstrate YMg's metallic properties. At atmospheric pressure (0 GPa), the total density of states (TDOS) near the Fermi level is approximately 1.63 states/eV, with pressure application reducing DOS. The dielectric function, refractive index, and energy loss spectra are examined within the 0–20 eV energy range. YMg exhibits its highest absorption between 4 and 11 eV. The peak optical conductivity is observed around 0.78 eV (equivalent to 1589.5409 nm), while the most significant energy loss occurs at 11.90 eV, roughly corresponding to 2.8 Hz in the ultraviolet spectrum. Moreover, we extensively analyzed the material's phonon thermodynamic and optical properties, providing insights into its behavior under various conditions. The outcomes acquired at zero pressure are generally coherent with the current theoretical values.

The structural, elastic and optical properties of ScM (M = Rh, Cu, Ag, Hg) intermetallic compounds under pressure by ab initio simulations

The high-pressure phase transitions and vibrational properties of zinc-blende XTe (X = Zn, Cd, Hg): Performance of local-density-approximation density functional theory

First-Principles Calculations for Elastic Properties of ZnS under Pressure

Structural, elastic, electronic and optical properties of the half-Heusler ScPtSb and YPtSb compounds under pressure

Investigation on different physical aspects such as structural, elastic, mechanical, optical properties and Debye temperature of Fe2ScM (M = P and As) semiconductors: a DFT based first principles study

First-principle Studies on the Mechanical, Thermodynamic and Electronic Properties of Β″-Mg3gd and Β′-Mg7gd Alloys under Pressure

Structural, mechanical, thermodynamic and electronic properties of Pt3M (M = Al, Co, Hf, Sc, Y, Zr) compounds under high pressure

Elastic Properties Of Single Crystal Hydrogen Sulfide: A Brillouin Scattering Study Under High Pressure-Temperature

The Mechanical and Thermodynamic Properties of Heusler Compounds Ni2xal (X = Sc, Ti, V) under Pressure and Temperature: A First-Principles Study

The Structural Stability of Mn3Sn Heusler Compound under High Pressure.

Structural, mechanical, thermal, magnetic, and electronic properties of the RhMnSb half-Heusler alloy under pressure

Semiconductor-metal transition in TlPbF 3 under isotropic pressure and its impact on optical, elastic and mechanical properties: A DFT computation with HSE06

A comment on the paper “The structural, elastic, electronic and optical properties of MgCu under pressure: A first-principles study”

Pressure induced Structural, electronic and optical properties of Sc 2 CBr 2 MXene Monolayer: A density functional approach

Theoretical prediction of structural, elastic and thermodynamic properties of transition metal monosilicides CrSi, TiSi and ZrSi under high pressure

Theoretical Investigation on Structural and Thermodynamic Properties of the Intermetallic Compound in Mg–Zn–Ag Alloy under High Pressure and High Temperature

Elastic, electronic, and optical properties of Sb2S3 and Sb2Se3 compounds: ab initio calculation

Pressure-induced effects on the mechanical and thermophysical properties of LiAl2X (X = Rh, Pd, Ir and Pt) ternary intermetallic compounds

First-principles exploration of the pressure dependent physical properties of Sn4Au: a superconducting topological semimetal

Pressure Effects on the Structural, Electronic, Elastic, Optical, and Vibrational Properties of YMg Intermetallic Compounds:A First-Principles Study

Pressure tuning the lattice and optical response of silver sulfide