Abstract:The direct injection hydrogen internal combustion engines avoid backfires and have a higher power density, especially when coupled with a turbocharger. However, while previous researches have focused on specific aspects of direct injection hydrogen internal combustion engines, their whole combustion characteristics remain largely unclear. Therefore, this study aims to comprehensively investigate the combustion characteristics of turbocharged direct injection hydrogen internal combustion engines across the entire operating map in order to optimize their performance. The combustion characteristics are hypothesized to be significantly influenced by operating parameters, including the equivalence ratio, spark timing, start of injection, and other relevant factors. To achieve this, the experiments were conducted on a 2.0 L turbocharged direct injection hydrogen internal combustion engine, covering a wide range of operating conditions. Specifically, the engine speeds varied from 1000 to 4000 rpm, loads ranged from 3.7 to 10.6 bar, equivalence ratios spanned from 0.33 to 0.71, spark timing was adjusted within a range of 21 degrees of crank angle, and start of injection varied within a range of 80 degrees of crank angle. The experimental results reveal notable findings regarding the turbocharged direct injection hydrogen internal combustion engine. For instance, the maximum pressure rise rate of the turbocharged direct injection hydrogen internal combustion engine (3.85 bar/°CA at 1500 rpm) at various engine speeds at wide open throttle are greater than those of a turbocharged port fuel injection hydrogen internal combustion engine and a gasoline engine. Furthermore, variations in equivalence ratio and spark timing cause significant increases in pressure rise rate by 328.4% and 233.3%, respectively. The peak pressure rise rate characteristics provide valuable insights for optimizing the noise, vibration and harshness of turbocharged direct injection hydrogen internal combustion engines. Additionally, the burning duration demonstrates an initial increase and subsequent decrease with changes in the start of injection, aiding in the determination of the optimal start of injection for achieving high brake thermal efficiency. Overall, this research provides valuable insights into the macroscopic combustion characteristics of a turbocharged direct injection hydrogen internal combustion engine across different operating conditions. These findings not only can be directly applied to hydrogen internal combustion engines of the same displacement and type, but also can be applied to the design and development of hydrogen internal combustion engines with different displacements and types.

Influence of operating parameters on hydrogen DISI engine at injection pressure-drop by experimental investigation and Taguchi method

Experimental study on the combustion and emission performance of the hydrogen direct injection engine

Experimental Study on the Impact of Hydrogen Injection Strategy on Combustion Performance in Internal Combustion Engines

Numerical Investigations of Injection Timing Effects on a GDI Engine Performance: Part B, In-Cylinder Emission Formation and Oxidation Process

Investigation on the combined influence mechanism of port water injection timing, injection pressure and ignition timing on natural gas engine performance based on the Taguchi method

Effects of hydrogen injection timing and injection pressure on mixture formation and combustion characteristics of a hydrogen direct injection engine

Effect of hydrogen direct injection on natural gas/hydrogen engine performance under high compression-ratio conditions

Experimental and simulation research on the lean combustion characteristics of direct-injection hydrogen engine

Numerical investigation on gaseous fuel injection strategies on combustion characteristics and NO emission performance in a pure hydrogen engine

An experimental investigation on the lean-burn characteristics of a novel hydrogen fueled spark ignition engine: Hydrogen injection via a micro-hole on the spark plug

Parametric analysis of hydrogen two-stage direct-injection on combustion characteristics, knock propensity, and emissions formation in a rotary engine

Experimental Investigation Of Impacts Of Engine Hardware, Operating Parameters And Combustion Performance On Particulate Emissions In A Disi Engine (Withdrawn Publication. See Vol. 215, Pg. 809, 2018)

Combustion characteristics of a turbocharged direct-injection hydrogen engine

Numerical Investigation on the Influence of Injection Location and Injection Strategy on a High-Pressure Direct Injection Diesel/Methanol Dual-Fuel Engine

Study on the Effects of the Hydrogen Substitution Rate on the Performance of a Hydrogen–Diesel Dual-Fuel Engine under Different Loads

Effects of second hydrogen direct injection proportion and injection timing on combustion and emission characteristics of hydrogen/n-butanol combined injection engine

Experimental Study on the Diesel Injection Pressure of Homogeneous Charge Induced Ignition for Multi-cylinder Operation

Study on the effect of variable valve timing and spark timing on the performance of the hydrogen-fueled engine with passive pre-chamber ignition under partial load conditions

Research on the inducing factors and characteristics of knock combustion in a DI hydrogen internal combustion engine in the process of improving performance and thermal efficiency

A model to determine the effects of low proportion of hydrogen and the flame kernel radius on combustion and emission performance of direct injection spark ignition engine

Experimental investigation of water injection and spark timing effects on combustion and emissions of a hybrid hydrogen-gasoline engine