Abstract:A different to conventional monitoring systems sensor equipped tools give the possibility to gain information about the process status directly from the contact zone between tool and component to be machined. For example this can be realized by the integration of small temperature sensors into grinding wheels. The transmitting of the process data is performed by a telemetric unit attached to the grinding wheel's core. In this paper, the development of a new thin film thermocouple sensor concept is described. The unique feature of this sensor is the continuous contacting of the thermocouple through the grinding process inherent wear which leads to smearing of the thermoelectric layers and thus forming the measuring junction of a thermocouple. The system was used in OD grinding processes aiming to detect grinding burn and process instabilities. By reducing the volume of the sensors a fast response and high time resolution can be obtained. By this way, observance of the key parameters of the practical operation as closely as possible to the cutting area is enabled and so observance of process efficiency and tool status independent from workpiece machining conditions can be realized. All sensors used are thermocouples of type K, a combination of Chromel (NiCr) and Alumel (NiAlMnSi) material. The maximum temperature to be measured by this sensor is about 1350 °C, which ensures the applicability in the grinding process. Telemetry components to amplify and send the thermovoltage signals are adjusted to this type of thermocouple. The ability of the set‐up to detect thermal influences was demonstrated in grinding processes with a continuously increasing specific material removal rate. The approach serves to measure temperatures between fast sliding surfaces in harsh environments (fluids, high pressure, heat), similar to the grinding process. Therefore their application is not limited to tools but also applicable for other rotating components such as bearings, gears and shafts in powertrains. A new thin film thermocouple sensor concept, usable for grinding tool integration, is described in this paper. The unique feature of this sensor is the continuous contacting of the thermocouple through the grinding process inherent wear which leads to smearing of the thermoelectric layers and thus forming the measuring junction of a thermocouple.

Concept of a sensor-integrating jaw coupling for measuring operating data

Dielectric elastomer sensor integrated in a jaw coupling: Modeling and simulation of mechanical and electrical behavior

Sensor-integrating gears: wear detection by in-situ MEMS acceleration sensors

Design of a fully integrated sensor system of a plain bearing

Electromechanical Coupling and Signal Distribution of A Circular Cylindrical Shell Coupled with Segmented Sensors

Monitoring of Machining Processes Using Sensor Equipped Tools

An experimental study of the sensorized strain wave gear RT1-T and its capabilities for torque control in robotic joints

Development of an Inductively Coupled Magnetoelastic Torque Sensor

A versatile flexure-based 6-axes force/torque sensor and its application to tribology

A Reliable Wireless Sensor System for Monitoring Mechanical Wear-Out of Parts

A novel non-contact method for monitoring the Acoustic Emission from mixed EHL contacts

Design of Highly Sensitive Joint Torque Sensor for Collision Detection in Robotic Manipulators

Signal Processing Using a Circular Sensor Array to Measure the Torsional Angle of a Bolted Joint

Multi-Sensory Tool Holder for Process Force Monitoring and Chatter Detection in Milling

A Novel Approach for Detecting Rotational Angles of a Precision Spherical Joint Based on a Capacitive Sensor

Evaluation of vibration behavior at different sensing positions on gearboxes

Vibration-Based Wear Condition Estimation of Journal Bearings Using Convolutional Autoencoders

A Passive Non-Interference Scheme for Synchronously Measuring Multiple Parameters With Single Sensing Unit

Highly Reliable Multicomponent MEMS Sensor for Predictive Maintenance Management of Rolling Bearings

Experimental study of a teeth flux sensor for detection, location and severity evaluation of induction machine stator faults

Application of sophisticated sensors to advance the monitoring of machining processes: analysis and holistic review