Signal Processing Using a Circular Sensor Array to Measure the Torsional Angle of a Bolted Joint

Thorben Schüthe,Karl-Ragmar Riemschneider,Andreas Meyer-Eschenbach

DOI: https://doi.org/10.3390/s24092719

IF: 3.9

2024-04-25

Sensors

Abstract:This study presents a new approach to determining the preload force of bolted joints. The concept involves measuring the torsional angle without contact. For this purpose, we present a circular magnetic sensor array integrated into the torque wrench. The torsional angle in bolted joints depends on the dimensions of the screw and the materials used and is typically less than four degrees. For this reason, one requirement is a high angular resolution so that a continuous recording of the torsion angle is feasible during the assembly process. This can be achieved using the circular sensor array and adapted signal processing methods. Two signal processing approaches are utilized. First, the direct method uses the discrete Fourier transformation to calculate the rotation angle from the signal phase. This approach is robust to signal distortion and does not depend on signal amplitude. Second, the method with a learning phase employs Gaussian process regression to minimize the angle error. In an experiment, both approaches were applied within a test bench and showed promising results. The direct method demonstrated a very good angular resolution without training and calibration. For mobile and less-complex applications where a reference system is unavailable, the direct method is preferable. However, in complex measurement systems where reference systems can be utilized initially, significant enhancements to an excellent resolution can be achieved through prior training.

engineering, electrical & electronic,chemistry, analytical,instruments & instrumentation

What problem does this paper attempt to address?

The problem that this paper attempts to solve is to accurately measure the preload force in bolted connections. Although traditional digital torque wrenches can measure the applied torque, these devices cannot fully and accurately determine the preload force because the influence of friction on bolts is significant and, in practical assembly applications, friction can only be roughly estimated. Therefore, the paper proposes a new method based on torsional angle measurement to overcome this challenge. Specifically, this method non - contactedly measures the torsional angle in bolted connections by using a circular magnetic sensor array integrated in the torque wrench, thereby indirectly calculating the preload force.

The paper mentions that the torsional angle in bolted connections depends on the size of the bolt and the materials used, and is usually less than 4 degrees. Therefore, in order to continuously record the torsional angle during the assembly process, high - angle resolution is required. The paper shows how to achieve this by using a circular sensor array and an adapted signal - processing method, and compares the effects of two signal - processing methods: the direct method (calculating the rotation angle from the signal phase using the discrete Fourier transform) and the method with a learning phase (minimizing the angle error using Gaussian process regression). The experimental results show that both methods can effectively improve the accuracy of angle measurement. Among them, the direct method can obtain good angle resolution without training and calibration, and is suitable for mobile or less - complex applications; while the method with a learning phase can significantly improve the resolution in complex measurement systems through initial or continuous use of the reference system.