Abstract:3D‐compliant thermoelectric generators (TEGs) fabricated solely by direct ink writing through out‐of‐plane printing of viscoelastic carbon nanotube‐based thermoelectric (TE) inks are proposed. By optimizing 3D structural design and doped printable TE materials, TEGs exhibit the highest TE performance among printed TEGs and outstanding mechanical reliability. Compliant thermoelectric generators (TEGs) can fully exploit their energy conversion efficiency by establishing conformal interfaces on arbitrarily shaped 3D heat sources. Although additive manufacturing processes allow scalable fabrication with flexibility and customizability, most printable TEGs are fabricated as planar‐type devices that harvest heat only in the in‐plane direction. Herein, 3D‐compliant TEGs fabricated solely using direct ink writing, which enables thermal‐transfer optimization for efficient through‐plane heat‐to‐electricity conversion owing to the out‐of‐plane printing of viscoelastic thermoelectric (TE) inks and unique device design is proposed. The rheological properties of carbon nanotube (CNT) TE inks are engineered to ensure conformal printing along directly written vertical thermal insulators. The ink TE properties are enhanced by the fine‐tuned incorporation of p‐ and n‐type dopants, where the electrical conductivity is further facilitated by nozzle‐induced CNT packing to achieve high‐power factors. To minimize the parasitic thermal loss from heat sources, an ultra‐thin bottom substrate is directly printed with polydimethylsiloxane, thereby realizing compliant 3D TEGs for heat harvesting in the out‐of‐plane direction. The TEG exhibits the highest normalized open‐circuit voltage (0.28 mV K−1 cm−2) among the additively manufactured TEGs and retains remarkable mechanical reliability against repetitive deformation, promising its potential as body heat harvesters or temperature sensors.

Additive Manufacturing of Thermoelectric Microdevices for 4D Thermometry (Adv. Mater. 35/2023)

Additive Manufacturing of Thermoelectric Microdevices for Four‐Dimensional Thermometry

Ion Write Microthermotics: Programing Thermal Metamaterials at the Microscale

Additive Manufacturing of Thermoelectrics: Emerging Trends and Outlook

Machine Learning-Assisted 3D Printing of Thermoelectric Materials of Ultrahigh Performances at Room Temperature

Direct ink writing of three-dimensional thermoelectric microarchitectures

Thermoelectric materials and devices fabricated by additive manufacturing

3D-Printing of Shape-Controllable Thermoelectric Devices with Enhanced Output Performance

Additive manufacturing of thermoelectric materials: materials, synthesis and manufacturing: a review

3D Printing: 3D Printing Fabrication of Amorphous Thermoelectric Materials with Ultralow Thermal Conductivity (Small 44/2015)

Thermoelectric Nanowires for Dense 3D Printed Architectures (vol 11, Pg 847, 2024)

Reversible Solar Heating and Radiative Cooling Devices via Mechanically Guided Assembly of 3D Macro/Microstructures (Adv. Mater. 39/2024)

3D-Printed Soft Temperature Sensors Based on Thermoelectric Effects for Fast Mapping of Localized Temperature Distributions

3D Printing Fabrication of Amorphous Thermoelectric Materials with Ultralow Thermal Conductivity

Thermoelectric Materials—Strategies for Improving Device Performance and Its Medical Applications

Printing Three‐Dimensional Refractory Metal Patterns in Ambient Air: Toward High Temperature Sensors (Adv. Sci. 31/2023)

All Direct Ink Writing of 3D Compliant Carbon Thermoelectric Generators for High‐Energy Conversion Efficiency

Development of Thermoelectric Microdevices by Combining Materials Processing and Silicon Micromachining Technology

Toward thermoelectric characterization of (nano)materials by in situ transmission electron microscopy

Thermal Computing with Mechanical Transistors (Adv. Funct. Mater. 25/2024)