Abstract:The structural performance and design of extruded high-strength aluminium alloy square hollow section (SHS) columns were presented in this paper. A total of 12 extruded 7A04-T6 aluminium alloy SHS column specimens were tested under axial compression, together with tensile coupon tests and initial global geometric imperfection measurements. The flexural buckling failure mode and axial load versus end shortening and mid-height lateral deflection curves were reported. Based on validated finite element (FE) models, 480 numerical results were generated by means of parametric studies over a broad range of cross-section dimensions, member lengths, proof strengths and strain hardening exponents of the aluminium alloy material. The applicability of current design rules used for normal-strength aluminium alloy columns in European, Chinese and American standards to extruded 7A04-T6 high-strength aluminium alloy SHS columns was evaluated through comparisons with the test and FE results. The analysis results showed that the three standards consistently yielded conservative axial compression resistance predictions by about 9% for extruded 7A04-T6 high-strength aluminium alloy SHS columns. New flexural buckling curves with linear and nonlinear imperfection terms for the Chinese code, as well as modifications to the American specification, were separately proposed, resulting in improved accuracy with significantly reduced scatter. Additionally, the continuous strength method (CSM) was further extended for the flexural buckling design of extruded 7A04-T6 high-strength aluminium alloy SHS columns, and was shown to provide accurate and consistent resistance predictions. Reliability analyses of the codified and the proposed design methods were performed, confirming that the design proposals meet the target reliability indices except the Eurocode approach.

Stability properties of 6061-T6 aluminum alloy members with double-layer H-type sections under eccentric compression loads

Testing, Modelling and Design of Aluminium Alloy Single-Angle Members Connected by One Leg under Eccentric Compression

Experimental and Numerical Study of 7A04-T6 Extruded Aluminium Alloy Lipped Angle Columns in Axial Compression

Stability and Design of High-Strength Aluminium Alloy RHS Members under Eccentric Compression

Experimental Investigation into Flexural Buckling of Double-Limb Built-Up Plate Members under Compression

Numerical modelling of lockbolted lap connections for aluminium alloy plates

STABILITY OF DOUBLY SYMMETRIC I-SECTIONAL CANTILEVERS WITH DIFFERENT BOUNDARY CONDITIONS AT TIP

Research on lateral buckling of eccentrically compressed H-shaped section aluminum alloy perforated members

Testing and Design Methods for High-Strength Aluminium Alloy CHS Members under Combined Axial Compression and Bending

Experimental Investigation on the Stability of Aluminium Alloy 6082 Circular Tubes in Axial Compression

Research on Stability of High Strength Aluminum Alloy Columns Loaded by Axial Compressive Load

Local buckling and postbuckling strength of extruded aluminium alloy stub columns with slender I-sections

Experimental study and parametric analysis on the stability behavior of 7A04 high-strength aluminum alloy angle columns under axial compression

Research of Stability of Aluminum Alloy Axial Compression Members

Experimental Study on Axial Compression Performance of High-Strength Aluminum-Alloy Columns with H-Section

EXPERIMENTAL RESEARCH ON THE OVERALL STABILITY OF LARGE-SECTION ALUMINUM ALLOY COLUMNS UNDER AXIAL COMPRESSION

Experimental study on the lateral stability of aluminum bending members

Stability of 6082-T6 Aluminium Alloy Columns with H-Section and Rectangular Hollow Sections

Lateral-torsional Buckling Resistance of Aluminium I-beams

Study of Local Buckling Performance of 7075-T6 High-Strength Aluminium Alloy H-section Stub Columns

Flexural Buckling of Extruded High-Strength Aluminium Alloy SHS Columns