Abstract:The vertical takeoff and landing unmanned aerial vehicle (VTOL UAV) must ensure robust structural integrity and meet a 130 kg maximum takeoff weight (MTOW) requirement, as it functions as an aerial module within docking–undocking unmanned systems. To satisfy these requirements, the airframe structure of the unmanned aerial vehicle was carefully designed with appropriate load paths to ensure sufficient static margin of safety. The most reliable method to demonstrate the structural integrity of an aircraft design is to conduct static structural tests, adequately reflecting the ground and flight load conditions applied in the design. This paper presents the overall process and results of the static structural testing of the VTOL UAV. This includes the methods for determining and validating test loads, analyzing test results, and evaluating structural integrity. The wing structure, expected to support the highest loads, was chosen as the test specimen. To calculate and validate the test loads, the static structural test FEM (SST FEM) was generated. Based on the detailed design results of the airframe structure, five critical load conditions were chosen as test conditions, and test loads for each condition were defined using the SST FEM. The test loads were calculated to achieve an accuracy within 2% of the maximum VMT loads for the SST FEM, compared to the VMT design loads for the full-scale FEM. Static structural testing was conducted for all test load conditions, including limit load tests for each condition and one ultimate load test for a critical condition. From all test results, it was confirmed that no detrimental permanent deformation and catastrophic failure occurred, ensuring the structural integrity of the design. In addition, the test results measured from strain gauges were compared with the numerical results of the SST FEM to validate the finite element model and analysis methods used in the design process. The findings of this paper can serve as a reference for design criteria and structural integrity validation methods necessary for the development of VTOL UAVs of similar scales.

Static Structural Testing of Composite Wing Structure for Vertical Takeoff and Landing (VTOL) Unmanned Aerial Vehicles

Overall Evtol Aircraft Design for Urban Air Mobility

Conceptual Design and System Level Analysis of Tilt-Duct eVTOL Aircraft

Structural Design and Analysis for High Altitude Long Endurance UAV

Numerical and Experimental UAV Structure Investigation by Pre-Flight Load Test

Crashworthiness Design Optimization for an Evtol Aircraft.

Low-cost development of a fully composite fixed-wing hybrid VTOL UAV

Virtual Full Scale Static Test of a Civil Tilt Rotor Composite Wing in Non-Linear Regime

Analysis and Experimental Study for Fatigue Performance of Wing-Fuselage Connection Structure for Unmanned Aerial Vehicle

Stability Analysis for a Concept Design of Vertical Take-off and Landing (VTOL) Unmanned Aerial Vehicle (UAV)

Wind Tunnel Testing and Analysis of a Rigid, Variable Speed Rotor for eVTOL Applications

UAV Pre-flight Structural Strength Verification during On-ground Static Load Test

Evaluation of the Multiaxial Fatigue Life of Electro-Mechanical Actuator for Aircraft Blade Pitch Control Based on Certification Standards

Design and static testing of wing structure of a composite four-seater electric aircraft

Preliminary Design and Optimization of Primary Structures for a Tilt-Duct UAV

Design of High Altitude Long Endurance UAV: Structural Analysis of Composite Wing using Finite Element Method

Structural design and test verification of all-composite wing for unmanned aerial vehicle

Fluid Coupled Structural Analysis and Optimization of Expanded Polystyrene-Fiber-Reinforced Composite Wing of an Unmanned Aerial Vehicle

A Road Map to the Structural Optimization of a Type-C Composite UAV

Construction Prototyping, Flight Dynamics Modeling, and Aerodynamic Analysis of Hybrid VTOL Unmanned Aircraft

Study on the test load for the structural test of the flight-load condition of the external fuel tank for fixed-wing aircraft