Abstract:Due to the complex energy conversion processes and limited avenues for heat dissipation in the giant magnetostrictive transducer (GMT). Large losses and elevated internal temperature rise are inevitable, this would bring into serious reliability problem for GMT. Accurately analyzing its electromagnetic losses and hot-spots temperature are crucial for designing and optimizing the transducer. High-power GMT typically use permanent magnet (PM) to provide a bias magnetic field for enhanced power density. Although, this structure could significantly reduce the volume of driving part, it also caused issues such as non-uniform magnetic field distribution and bias magnetic field, which have great influence on the magnetic energy loss and hot-spots temperature rise. The previous researches seldomly investigate these influences on total loss at GMT system level. Additionally, the differential excitation coil loss caused by AC resistance among multi-layers can't be neglected, which can lead to variations in coil loss and temperature rise. Therefore, this paper proposed a detailed electromagnetic losses and hot-spots temperature rise calculation model from material level to GMT system level. This method can obtain the distribution of electromagnetic losses within multiple factors, and the hot-spots temperature rise considering the temperature non-uniform distribution. Firstly, we have developed a precise loss calculation model, which takes the influence caused by PM bias and non-uniform magnetic field on magnetic energy loss into account. Additionally, the proposed model could conclude the impact of inter-coil resistance variations on the eddy current loss in excitation coil. Secondly, based on of the non-uniform distribution of losses in driving part, using the divisional thermal modeling approach and a 2-D T-shaped equivalent thermal network, we further constructed a transient temperature calculation model for GMT. This approach can effectively improve the energy conversion efficiency of GMT, so as to enhance the thermal reliability of the transducer. Finally, a testing system for the loss-thermal of GMT was established to validate the effectiveness of proposed model. Results indicate that the average error between our loss calculation model and experimental results is 2.93%, while the corresponding error for without considering the above factors is 15.97%. This confirms the necessity of conducting a detailed electromagnetic losses calculation model. In addition, the average error of the temperature rise calculation model is less than 5%, while the error for without considering the losses distribution and heat dissipation paths difference is exceed 10%. In conclusion, our proposed method accords well with the measured results, and can provide significant fundamental for design and optimization of GMT.

Research on the high temperature calibration of the electromagnetic damping generator applied to the rotary steerable system

Experimental Research on Heat Conduction and Temperature Control Method in the Chamber of Large-Scale Geotechnical Centrifuge

Multiphysics Co-Simulation and Experimental Study of Deep-Sea Hydrothermal Energy Generation System

Innovative Design and Simulation of a Downhole Turbine Generator for the Rotary Steerable System

Thermal Optimization of High-Temperature Downhole Electronic Devices

Thermal Management of the High-power Electronics in High Temperature Downhole Environment

Analysis and Design of Embedded High-Temperature Doubly Salient Electro-Magnetic Starter/Generator for Aviation

The Impact of the High Temperature on the Performance of Critical Components in the Htr-Pm Control Rod Drive Mechanism

Thermal Management for High-Power Downhole Electronics Using Liquid Cooling and PCM under High Temperature Environment

Calculation method of electromagnetic losses and hot-spots temperature of giant magnetostrictive transducer

The Study And Development Of Excitation Source For Sensors Of The Amb System In Htgr

Electrodes Optimization of an Annular Flow Electromagnetic Measurement System for Drilling Engineering

Experimental Study on Active Thermal Protection for Electronic Devices Used in Deep−Downhole−Environment Exploration

Temperature Measuring System in High Temperature Carbon Reducing Environment

From Design to Experimental Validation of the Fully Mechanical Gravity Tool Face Measurement-While-Drilling System

Magnetic Energy Losses and Temperature Control System for Giant Magnetostrictive Transducer

A Simulation Study on the High-Frequency Electromagnetic Heating Heavy Oil Reservoir and Analysis of Influencing Factors

Temperature Dependence Calibration and Correction of the DAMPE BGO Electromagnetic Calorimeter

Research on Optimization Technology of Excitation Coil in Downhole Annular Flow Electromagnetic Measurement System

Electromagnetic Coupling-Based Downhole Remote Telemetry In Well Testing

Numerical and Experimental Studies on Temperature Field of Rotary Mrf Dampers