Direct utilization of light energy to promote power density of zinc-air batteries by Co3O4@CuxO air photocathodes with porous octahedral superstructures

Yuhao Zhong,Jing Xie,Ruitong Xu,Xiaobo Feng,Ting Zhu
DOI: https://doi.org/10.1039/d4ta06461e/v2/review1
IF: 11.9
2024-11-28
Journal of Materials Chemistry A
Abstract:The commercialization of zinc-air batteries (ZABs) is essentially limited by low power density as well as poor cycling stability. Herein, photo-sensitive air cathode materials composed of CuxO (referring to CuO/Cu2O) and Co3O4 with porous octahedral superstructures were prepared to promote power density of ZABs. The highly electroactive Co3O4 species were grown against the CuxO octahedral particles through heat treatment, forming a homogeneous interspersion of Co3O4 and CuxO (Co3O4@ CuxO) with a reduced Gibbs free energy for OOH*. In virtue of the enhanced light adsorption, enriched electroactivity, porous superstructures, and lower energy barrier, the as-prepared Co3O4@CuxO air photocathode can achieve a lower charge potential of 1.759 V than that obtained without light (1.886 V), exhibiting a considerable energy saving of 6.7%. Moreover, the fabricated ZAB cells can deliver a maximum specific capacity of 759.12 mAh g-1 with a high power density of 76 mW cm-2, corresponding to light enhancements of 7.24% and 31%, respectively. The as-fabricated ZABs also exhibited a good stability up to 160 hours under light irradiation, indicating a promising direct utilization of light energy for ZABs cells.
materials science, multidisciplinary,chemistry, physical,energy & fuels
What problem does this paper attempt to address?