Abstract:The thermal deformation behavior of a novel TG6 titanium alloy from 850 to 1050 °C with a strain rate of 0.001-10 s−1 was studied using a Gleeble-3500 thermal simulation compressor. The constitutive model was established, then metallography was used to observe the evolution of microstructure under the influence of temperature or deformation rate, the evolution of α/β phase, and the angular distribution of grain boundaries during thermal deformation were described with the help of EBSD. The results after comprehensive analysis are as follows: TG6 titanium alloy is a strain rate and temperature-sensitive material, the flow stress increases with an increase in strain rate when the temperature is stable, and the flow stress decreases with increasing temperature at a stable strain rate. Furthermore, the flow stress increases rapidly with increase in strain in the initial stage of deformation; after reaching the maximum, it begins to decrease slowly until a relatively stable state. The morphology, size, and content of the phase can be affected by the deformation temperature and strain rate to a certain extent. The elongation and distortion of the α phase occur as the temperature falls below 950 °C and the strain rate increases above 0.01 s−1; besides, as the temperature rises near the phase transition point, the primary α phase begins to dissolve, the acicular α phase gradually precipitates from the coarse β phase and tends to continue coarsening. Finally, the combination of EBSD analysis and 3D hot processing map reveals that the dynamic recrystallization behavior is more evident at low temperatures and strain rates.

Role of the Pulse Current Duty Cycle during Titanium Tension

Cyclic deformation behaviour of commercially pure titanium at cryogenic temperature

Improvement of Mechanical Properties of Titanium Alloy by High-Density Pulsed Electric Current

Constitutive Model and Microstructure Evolution of a Novel TG6 High-Temperature Titanium Alloy during Hot Deformation

Influence of the Electric Pulse on Springback During Stretch U-bending of Ti6Al4V Titanium Alloy Sheets

Effect of high-density pulsed electric current on residual stress relief and microstructural modification of cold-bent commercially pure titanium

Characterization of stress drop and strain localization for titanium alloy subjected to electrically-assisted tension

Impact of plastic strain amplitude on the cyclic behavior of commercially pure titanium grade 2

Effect of pulse current treatment on interface structure and mechanical behavior of TA1/304 clad plates

Influences of pre-torsion deformation on microstructure and mechanical properties of pure titanium subjected to subsequent tension deformation

Effect of Pulse Current on Bending Behavior of Ti6Al4V Alloy

Pulse Current Auxiliary Tensile and Bulging of Light Metal Alloy

Enhancement of Ductility, Weakening of Anisotropy Behavior and Local Recrystallization in Cold-Rolled Ti-6Al-4V Alloy Strips by High-Density Electropulsing Treatment

RETRACTED: Effect of Electropulsing Treatment on Microstructure and Mechanical Properties of Cold-Rolled Pure Titanium Strips

Effect of Pulse Current on the Tensile Deformation of SUS304 Stainless Steel

Flow behavior and plasticity of Ti-6Al-4V under different electrically assisted treatments

Effect of electric current on microstructure and texture evolution of the Ti2AlNb alloy during hot deformation

Effect of Pulse Current Frequency on Mechanical Properties of TC4 Titanium Alloy with Prefabricated Defects

Effect of Angle between Pulse Current and Load Direction on Flow Stress of Ti-6Al-4V Alloy under Uniaxial Tension

Effect of hot plastic deformation and heat treatment on microstructure and properties Of TC11 titanium alloy

Influences of temperature and strain rate on deformation twinning of polycrystalline titanium