Abstract:<p>A 3‐D coupled model considering electromagnetic field, flow field, heat transfer, particle transport is developed to predict the effect of stirrer position on the magnetic field distribution, fluid flow streamlines, temperature distribution and inclusion removal in 180 mm× 220 mm billet continuous casting process, and the effect of stirrer position on the mold level fluctuation and slag entrapment behavior is also studied based on the homogeneous model. The casting temperature of molten steel is 1750 K, and the casting speed of billet is 0.9 m/min. The results indicate that as the stirrer center position is lowered, the maximum value of the magnetic induction intensity has almost no change, while the maximum value of the tangential electromagnetic force initially decreases followed by an increase. With the downward movement of stirrer center position, the decrease rate of central molten steel velocity slows down, and the range of the upper circulation flow zone increases. A lower stirrer center position increases the cooling of the billet, especially for the region near top surface. When the stirrer center position is moved from 515 mm to 815 mm, the removal ratio of inclusions increases, and the wave height of steel/slag interface decreases from 11.6 mm to 3.4 mm. A lower stirrer center position weakens the phenomenon of slag entrapment. Owing to the rotating flow of molten steel, the slag in the billet is mainly distributed at shell side rather than the billet center.</p><p>This article is protected by copyright. All rights reserved.</p>

Numerical Simulation of Torque Variation During Paste Mixing and Kneading

Numerical Simulation of Hydrodynamics and Mixing Characteristics of High-Viscosity Non-Newtonian Fluid in Twin-Shaft Kneaders

Hydrodynamics and mixing process in a horizontal self-cleaning opposite-rotating twin-shaft kneader

Mixing Intensification in a Horizontal Self-Cleaning Twin-Shaft Kneader with a Highly Viscous Newtonian Fluid

Hydrodynamics and Film Formation Characteristics in a Horizontal Self‐cleaning Twin‐shaft Kneader for Polymer Devolatilization

Study on Mixing Performance of Kneading Section of Rotors in Large-Scale Twin-Rotor Continuous Mixer

Mixing performance in an asymmetrical non-twin kneading element channel

Numerical Simulation and Experimental Validation of Mixing Performance of Kneading Discs in A Twin Screw Extruder

Dough kneading load simulation for stand mixer using smoothed particle hydrodynamics approach

Numerical simulation on flow and heat transfer in twin roll strip casting and rolling molten pool with side dams vibrating

Numerical and experimental study of homogenization mechanism of high shear rotor‐stator mixer

Numerical Simulation of Rotor-stator Mixer with Viscous Fluids

An experimental study of localized flow pattern, strain rate and turbulence kinetic energy dissipation rate of in-line teethed high shear mixer with different rotor and stator structures

Numerical Simulation of Particle Mixing Behavior in High Speed Shear Mixer and Cylinder Mixer

EFFECT OF OPERATING CONDITIONS ON THE MIXING PERFORMANCE OF THE SCREW ELEMENT AND THE KNEADING BLOCK IN A TWIN-SCREW EXTRUDER

Numerical study of mixing dynamics inside the novel elements of a corotating nontwin screw extruder

Numerical simulation of micromixing effect on the reactive flow in a co-rotating twin screw extruder

Simulative Analyses and Experimental Researches of Three Forms of the Kneading Equidirectional Twin Screws

Numerical Simulation on Multiple Physical Fields Behaviors in Billet Continuous Casting with Different Stirrer Positions

Numerical Optimization Simulation of Synchronous Four-Wing Rotor.

Effects of pitched tips of novel kneading disks on melt mixing in twin-screw extrusion