Abstract:A novel, self‐cleaning, corotating nontwin screw configuration is proposed, and its geometry is briefly introduced in this study. In this new configuration, one single‐tip screw element intermeshes with another two‐tip screw element at a speed ratio of 2. A numerical simulation of the three‐dimensional flow field in this new kind of conveying system, as well as in the conventional twin screw configuration, was carried out using the finite element method (FEM) and the mesh superposition technique (MST) provided by the commercial CFD code POLYFLOW. The purely viscous fluid is assumed to obey the Bird–Carreau constitutive model. Based on the predicted flow field in the domain FEM mesh, post‐treatment codes have been developed to predict the mixing details where standard fourth‐order Runge–Kutta schemes were used. Flow patterns and mixing dynamics were presented in terms of the mixing evolution of the particle group released from different initial positions and the variation of the variance index, mixing index, strain tensor magnitude, and their time histories. Trajectories of the particle groups were captured successfully, and an obvious difference with regard to flow pattern and mixing was found for different types of screw geometries. The numerical results showed that mixing was highly dependent on the initial position of the particles and that the nontwin screw configuration had better distributive and dispersive mixing abilities than the conventional twin screw configuration.

Simulative Analyses and Experimental Researches of Three Forms of the Kneading Equidirectional Twin Screws

Hydrodynamics and mixing process in a horizontal self-cleaning opposite-rotating twin-shaft kneader

Numerical Simulation of Hydrodynamics and Mixing Characteristics of High-Viscosity Non-Newtonian Fluid in Twin-Shaft Kneaders

Mixing Intensification in a Horizontal Self-Cleaning Twin-Shaft Kneader with a Highly Viscous Newtonian Fluid

Evolution of residence time distribution and fill degree in co-rotating twin-screw extruder

Finite Element Analysis and Optimal Researchon Plasticizing Capacity of Screws

EFFECT OF OPERATING CONDITIONS ON THE MIXING PERFORMANCE OF THE SCREW ELEMENT AND THE KNEADING BLOCK IN A TWIN-SCREW EXTRUDER

Numerical Simulation and Experimental Validation of Mixing Performance of Kneading Discs in A Twin Screw Extruder

The Screw Geometry of Parallel Twin-Screw Extruder

Effects of Screw Reciprocation and Pin Arrangement of Buss Kneader on Mixing Performance

Study on Mixing Performance of Kneading Discs in Series Disc-Screw Extruder

Mixing performance in an asymmetrical non-twin kneading element channel

Numerical Study on Particle Mixing in a Double-Screw Conical Mixer

Numerical study of mixing dynamics inside the novel elements of a corotating nontwin screw extruder

Three-dimensional Numerical Study of the Mixing Behaviour of Twin-screw Elements

Simulation of Agglomerate Dispersion in Kneading Blocks

Melt-Mixing by Novel Pitched-Tip Kneading Disks in a Co-Rotating Twin-Screw Extruder

3-D Non-isothermal Numerical Simulation of the Effect of Temperature Mixing in Mixing Screw Head of Co-Rotating Twin-screw Extruder

Non-Isothermal Simulation of Melting Process in Twin Screw Extruder Based on Two Typical Screw Configurations

Study of Dynamic Flow and Mixing Performances of Tri-Screw Extruders with Finite Element Method

Study on Mixing Performance of Kneading Section of Rotors in Large-Scale Twin-Rotor Continuous Mixer