Synthesis and characterization of Mo-doped PbS thin films for enhancing the photocatalytic hydrogen production

Mohamed Ibrahim,Mohamed Zayed,Ashour M. Ahmed,Mohamed A. Ghanem,Mohamed Shaban,S. Abd Elkhalik,Fatma Mohamed
DOI: https://doi.org/10.1016/j.matchemphys.2024.128962
IF: 4.778
2024-01-28
Materials Chemistry and Physics
Abstract:Photocatalytic hydrogen production has gained considerable attention as a sustainable method for renewable energy production. Lead sulfide (PbS) compound has significant reserves and a suitable bandgap for the production of hydrogen gas via the water photo-splitting process. However, the charge recombination effect of the charge carriers severely limits their potential use in solar water splitting. Herein, the photoelectrodes of PbS were fabricated through the chemical bath deposition method and then doped with different Mo concentrations to optimize the hydrogen photo-production activity. Both structural and performance characterizations of the photoelectrodes have been carried out using various characterization techniques. The photoelectrochemical (PEC) performance of molybdenum (Mo)-doped PbS photoelectrodes exhibits a significant increase in the photocurrent density with the optimum photocurrent density of 1.2 mA/cm 2 obtained at 0.8 % Mo doping atomic ratio which was twelve times higher than that of a pure PbS photoelectrode. The doping of Mo induces the electron-hole separation yield which results in improved electron transport characteristics. The Mo doping was as act as a donor site that increased the PbS film conductivity. The newly optimized Mo–PbS was used as a promising photoelectrode supported on commercial glass using the optimum Mo-doped PbS photoelectrode, the photoelectrochemical (PEC) hydrogen production rate was reached 122 μmol/h cm 2 during the solar water splitting process and the conversion efficiency of the incident photon-to-current (IPCE) value was 7.0 % at 390 nm monochromatic exposure. Moreover, the stability of the optimum electrode was evaluated as a function of the number of runs and exposure time in addition to the electrochemical impedance study.
materials science, multidisciplinary
What problem does this paper attempt to address?