Abstract:Polymer Flooding has become one of the most implemented EOR techniques, due to three factors: First, Polymer flooding has expanded the range of the screening criteria parameters. Second, this EOR method is more effective than water injection, while handling water management issues in high water-cut reservoirs. Nevertheless, polymer retention can turn a viable technical project into an uneconomical one. Polymer loss due to retention is an inevitable phenomenon, which happens during injection processes. The development of experimental analysis aiming to minimize or reduce polymer loss from the displacing fluid bank is beneficial to broaden the application of this CEOR method. This experimental work evaluated the injection schemes aiming to reduce polymer retention in porous media. The approach consisted of injecting less-concentrated polymer banks followed for the main polymer bank designed for mobility control. An experimental methodology to quantify polymer retention due to each injected polymer bank, cumulative polymer retention, resistance factor, residual resistance factor and inaccessible pore volume (IPV) was developed. The measurement process was based on the injection of 20 PV polymer banks at a constant flow rate of 1ml/min at 25°C, separated by 30 PV brine banks. Two HPAM with molecular weights of 6-8 million and 20 million Daltons using 350mD and 5000 mD sandstone cores were tested, respectively. The HPAM solutions considering a Colombian field (0.7% NaCl) and seawater (3.5% TDS) salinities were prepared. All rock samples were previously submitted to the injection of 50 PV for preventing fines migration. Two injection schemes with variable polymer concentrations were performed: The first one in which the polymer concentration increased in each successive bank, and the second one in which the concentration decreased. HPAM concentration solutions from 50 ppm to 2000 ppm were sequentially used in both injection schemes. By comparing the results of these two schemes, the effect of the injection of the less-concentrated polymer solutions was evaluated. For the increasing concentration experiments, cumulative retention values of 175.7 μg/g and 58.9 μg/g were calculated for the low-molecular weight polymer and the high-molecular weight polymer, respectively. While comparing with decreasing concentration experiments, for the high-molecular weight HPAM a 19% of retention reduction was evidenced, but no retention reduction was observed for the low-molecular weight one. The results indicate that different retention mechanisms are strongly dependents on the absolute permeability of the samples. Additionally, IPV values of 0.5 PV and 0.25 PV were calculated using low and high permeability samples, respectively. There was no linear relation between the absolute permeability reduction and the polymer concentration of the first bank injected into the sample. The novelty of this work is to use sacrificial banks of less-concentrated HPAM solutions as a reducing retention agent for the polymer bank designed for mobility control.

Is There a Viscoelastic Effect of Low-MW HPAM Polymers on Residual Oil Mobilization in Low-Permeability Rocks at a Darcy Velocity of 0.2 ft/Day?

Next-Generation Gelling Agents for Improved Displacement in Enhanced Oil Recovery Processes

Smart Nanoparticles for Conformance Improvement in Waterflooding

Production Optimization under Injection of Biopolymer, Synthetic Polymer and Gels in a Heterogeneous Reservoir

Optimization of Recovery under Injection of Biopolymer, Synthetic Polymer and Gels in a Heterogeneous Reservoir

Next-Generation Displacement Fluids for Enhanced Oil Recovery

Polymer Injectivity: Investigation of Mechanical Degradation of EOR Polymers Using In-Situ Rheology

Enhancing Oil Recovery from Low-Permeability Reservoirs with a Self-Adaptive Polymer: A Proof-of-concept Study

Potential of Associative Polymers as Mobility Control Agents in Low Permeability Carbonates

Effect of water saturation on the role of polymer elasticity during heavy oil recovery

Influence of Polymer Viscoelasticity on Microscopic Remaining Oil Production

Influence of Polymer Concentration on the Viscous and (Linear and Non-Linear) Viscoelastic Properties of Hydrolyzed Polyacrylamide Systems in Bulk Shear Field and Porous Media

Enhancing Oil Recovery in Low-Permeability Reservoirs Using a Low-Molecular Weight Amphiphilic Polymer

Polymers for EOR Application in High Temperature and High Viscosity Oils: Rock–Fluid Behavior

Influencing factors for effective establishment of residual resistance factor of polymer solution in porous media

Low-Salinity Polymer Flood for Enhanced Oil Recovery in Low-Permeability Carbonates

Influence of viscosity ratio on enhanced oil recovery performance of anti-hydrolyzed polymer for high-temperature and high-salinity reservoir

Microflow Mechanism of Oil Displacement by Viscoelastic Hydrophobically Associating Water-Soluble Polymers in Enhanced Oil Recovery

Experimental Investigation of a Mechanically Stable and Temperature/Salinity Tolerant Biopolymer toward Enhanced Oil Recovery Application in Harsh Condition Reservoirs

Less-Concentrated HPAM Solutions as a Polymer Retention Reduction Method in CEOR

Enhancing heavy‐oil displacement efficiency through viscoelasticity of polymer solution by investigating the viscosity limit of crude oil: An experimental study