Abstract:Grinding executed in a lapping configuration is an alternative finishing process benefiting from both grinding and free-abrasive machining, while minimizing the heat effect impact. Electroplated tools can be effectively used in different abrasive processes, including high-speed grinding, however, the assessment of machining performance over time is a key factor in their correct use to achieve satisfactory technological results. In conventional grinding, bigger grain-coverage provides better results due to the higher bonding strength of grains. In lap-grinding, fracturing and crushing of the abrasive particles initially covered by the plating result in a suspension which is typically dosed continuously in free-abrasive machining. Due to this, the process transforms from two-body (grinding) to three-body abrasion (free abrasive machining) which may result in reduced grinding performance approaching asymptotically a specific value while improving surface finish. The main aim of the presented study is the evaluation of electroplated CBN tools used in lap-grinding of 40H alloy steel workpieces whose hardness was 54 HRC. The obtained results and observations of the working surface of CBN wheels and workpieces allowed for the identification of the wear characteristics for three nickel plating thicknesses corresponding to 35%, 50% and 65% of the nominal CBN crystal size and for specific process parameters. The surface roughness Ra parameter decreased gradually from the initial value 1.9 μm to the values below 0.7 μm for bigger B107 grains and for all plating thicknesses. For smaller B64 grains, the surface roughness and waviness parameters reached similar values to those obtained for the larger B107 grains at corresponding processing times. The lowest value of Ra parameter below 0.4 μm was obtained for B64 grains and for the thinnest plating but with a 50% reduction in material removal comparing to B107 grains. The Preston equation was employed to calculate the material removal as a function of time under variable process conditions in the machining zone due to the tool wear. This attempt extended the range of the material removal modeling, despite the fact that the electroplated wheels were subject to wearing down resulting in the gradual reduction in the efficiency, as well as in the change of the working conditions in the workpiece-tool contact zone.

Grinding Path Planning of Abrasive Cloth Wheel Based on Modified Preston Equation

An Intelligent Prediction of Surface Roughness on Precision Grinding

A novel tool path generation algorithm for plane envelope grinding convex surface based on constant scallop height method

A high-precision prediction model of surface roughness in abrasive belt flexible grinding of aero-engine blade

Prediction of contact characteristics of abrasive belt compliant grinding for aircraft blades

On the path planning method of polishing tool based on the abrasive belt flap wheel

Collaborative improvement of profile accuracy and aerodynamic performance in robotic grinding of transonic compressor blade leading edge

An efficient generation grinding method for spur face gear along contact trace using disk CBN wheel

Path Generation Method for Robotic Blades Grinding Based on Predictive Control and Extended Kalman Filter

A parametric evaluation model of abrasive interaction for predicting tooth rough surface in spiral bevel gear grinding

The use of Preston equation to determine material removal during lap-grinding with electroplated CBN tools

Accurate modeling of material removal depth in convolutional process grinding for complex surfaces

An iterative optimization algorithm for posture and geometric parameters of grinding wheel based on cross-section sensitivity and matching constraints of solid end mills

Path Planning For Automatic Robotic Blade Grinding

Research on flexible base discrete adhesion model of SCAPW for blade machining

Numerical modeling of material removal mechanism and surface topography for gear profile grinding

Enhancement and evaluation in path accuracy of industrial robot for complex surface grinding

An adaptive grinding method for precision-cast blades with geometric deviation

An optimized calculation method of the grinding wheel profile for the helical flute forming grinding

A model for material removal of robot-assisted blade polishing using abrasive cloth wheel

Optimization of Tool Path for Uniform Scallop-Height in Ultra-precision Grinding of Free-form Surfaces