Abstract:Wastewater treatment based on activated sludge processes faces a major challenge due to an increased number of people contributing to wastewater and changes in wastewater characteristics in regions with seasonal winter tourism. The combination of significant increases in carbon (COD) and nitrogen (N) loads by a factor of four to five within a short periode of time and low wastewater temperatures (<12 °C), represents a bottleneck in meeting essential effluent requirements. According to literature research, however, little attention has been paid to these special framework conditions for wastewater treatment. Based on this fact, a model-based simulation study of the wastewater treatment plant (WWTP) in Montafon (Austria) evaluates operational optimization approaches for the above-mentioned framework conditions and is intended to provide new insights for nitrification-optimized and energy-optimized wastewater treatment. The WWTP Montafon is designed for a COD load of 6250 kg d −1 , a daily dry weather water discharge of 12,700 m 3 d −1 and is a typical plant in a winter tourism region. The 5 studied smart operation approaches shown are a combination of two different aeration control strategies based on a time-controlled (i) or ammonia-based feedback aeration control (ABAC) (ii) for intermittent nitrification-denitrification and sludge removal control strategies based on a constant sludge concentration to 3 g L −1 (iii), a constant sludge retention time (SRT) to 20 days (iv) and a constant sludge retention time to 20 days combined with a higher level sludge concentration control to max. 3 g L −1 (v). The simulation results show that a combination of a time-controlled aeration strategy and controlling the sludge concentration to a constant 3 g L −1 is not recommended in order to comply with the emission limits. Under the mentioned influent conditions, ABAC control alone does not inevitably lead to a nitrification-optimized process and reduction in energy consumption. Sufficient nitrifying bacteria in the activated sludge are the key to a nitrification optimized process and reduction of energy consumption for aeration. Hence, a combination of an intermittent aeration control based on ammonium measurement and a constant sludge retention time to 20 days is preferable for nitrification capacity and is the most energy-efficient control strategy to obtain required COD and N effluent quality. An average energy consumption of 57–63 Wh PE 120 −1 d −1 for the aeration is to be expected for combinations of (i,iv), (ii, iii) (ii,iv) and (ii,v) which is low in relation to the influent challenges and to plants with higher wastewater temperatures (>12 °C) between 27 Wh PE 120 −1 d −1 and 121 Wh PE 120 −1 d −1 according to literature. The approach with a time-controlled intermittent aeration and a SRT to constant 20 days was implemented at the WWTP Montafon and confirms the results of the associated simulation. According to this simulation study, a 35 % increase in nitrification capacity in existing WWTPs designed as activated sludge processes can be achieved through optimized operating conditions without additional high investments.

Novel dissolved oxygen distribution model of a full-scale aeration tank for a municipal wastewater treatment plant in a cold climate region

Determination of critical dissolved oxygen for effective mass transfer of activated sludge flocs based on microelectrode detection technology

Simulation and optimization of ammonia removal at low temperature for a double channel oxidation ditch based on fully coupled activated sludge model (FCASM): a full-scale study.

Numerical modelling of surface aeration and N2O emission in biological water resource recovery

The trade-off between N2O emission and energy saving through aeration control based on dynamic simulation of full-scale WWTP

A three-phase Eulerian–Lagrangian model to simulate mixing and oxygen transfer in activated sludge treatment

Evaluation of Oxygen Transfer Parameters of Fine-Bubble Aeration System in Plug Flow Aeration Tank of Wastewater Treatment Plant.

Aeration strategy based on numerical modelling and the response mechanism of microbial communities under various operating conditions

Modeling a Combined Anaerobic/Anoxic Oxide and Rotating Biological Contactors Process under Dissolved Oxygen Variation by Using an Activated Sludge-Biofilm Hybrid Model

Oxygen Transfer Rate in a Coarse-Bubble Diffused Aeration System

Model-based dynamic simulation study to boost the WWTP performance in winter tourism regions

Aeration of large-scale municipal wastewater treatment plants: state of the art

Manipulating dissolved oxygen concentration to control the partitioning between carbon oxidation and redirection in the A-stage high rate activated sludge process

CFD as a Tool to Optimize Aeration Tank Design and Operation

CFD Simulation of Aeration and Mixing Processes in a Full-Scale Oxidation Ditch

NONLINEAR FUZZY CONTROL SYSTEM FOR DISSOLVED OXYGEN WITH AERATION SYSTEM IN SEQUENCING BATCH REACTOR

Dynamic α-factor models for fine-bubble- and surface aeration – impact of settleability and implications on N 2 O emission

A Novel Method to Determine Blower Capacity of Wastewater Treatment Plants for Dry and Wet Weather Conditions

Numerical model for simulating the hydraulic parameters of the aeration system ensuring equal oxygenation of the compost heap

Impact of oxygen transfer dynamics on the performance of an aerobic granular sludge reactor

The Performance of Aerobic Granular Sludge Under Different Aeration Strategies at Low Temperature