Abstract:The as-cast and annealed Fe 76 Si 19.4 Nb 2.7 Cu 1.7 P 0.2 ribbons with width of 2.5 cm prepared by a single-roller cooling method were investigated. The structural properties of ribbons were studied by X-ray diffraction (XRD) and field emission scanning electron microscopy (FE-SEM). The XRD result shows the α-Fe crystal phase of annealed film. The average crystallite sizes of the as-cast and annealed ribbons are about 28 nm and 43 nm obtained from EF-SEM. The dielectric and magnetic properties of ribbons were tested over frequency ranges of 5 MHz to 300 MHz and 5 MHz to 3000 MHz using an Impedance Analyzer, respectively. The dielectric constant and dielectric loss of the as-cast ribbon decreases from 4.3 × 10 5 to 180 and from 3.01 to 0.06, while that of annealed ribbon decreases from 2.5 × 10 4 to 180 and from 3.01 to 1.31. The permeability decreased with increasing frequency at first of each ribbon and the value of annealed ribbon is bigger. It was observed that the permeability loss value of annealed ribbon is smaller at first and then bigger than that of as-cast ribbon. The smallest values of permeability of the as-cast and annealed ribbons are about 1.4 and 1.8. The minimum of the permeability loss of the as-cast ribbon is 0.008. The magnetic hysteresis loops were investigated using a vibrating sample magnetometer. The saturation magnetizations of the as-cast and annealed ribbons are 113 emu g −1 and 123 emu g −1 . The coercive fields of the as-cast and annealed ribbons are 259 A m −1 and 1130 A m −1 . The saturation magnetization and coercive field could become bigger due to the crystallize property.

Vacuum processing pressure and degradation performance of FePC ribbons in methylene blue solution

Effects of Chilling-Roll Materials and Ambient Pressure on the Microstructure and Magnetic Properties of Nanocomposite Nd2fe14b/Alpha-Fe Magnets

Light Activated Methylene Blue Degradation by Magnetic Fe80PxC20-x (x = 0, 4, 7 and 13) Glassy Ribbons

High MB Solution Degradation Efficiency of FeSiBZr Amorphous Ribbon with Surface Tunnels

Improving the degradation and magnetization performance of FePC amorphous alloys by annealing treatment

Enhanced Dye Degradation Capability and Reusability of Fe-based Amorphous Ribbons by Surface Activation

Excellent dye degradation performance of FeSiBP amorphous alloys by Fenton-like process

Synthesis of enhanced corrosion resistant Fe-B-C-Ti amorphous ribbons and evaluation of their photodegradation efficiency under light irradiation

Fenton-like Degradation of Methylene Blue Using Paper Mill Sludge-Derived Magnetically Separable Heterogeneous Catalyst: Characterization and Mechanism.

Amorphous-nanocrystalline dual-phase structured Fe78Si13B9 alloy ribbons and their efficiency for degradation of direct yellow dye

Degradation of PVDF-Coated Fabrics after Engineering Applications: Correlations between Surface Microstructure, Physical Properties, and Mechanical Properties Based on Statistical Analysis

Unexpected High Performance of Fe-Based Nanocrystallized Ribbons for Azo Dye Decomposition

Developing PVDF Hollow Fiber Membrane Enhanced by Braided Tube and Modified by Bionic Coating for Treating Aldehyde-Containing Wastewater

Effect of CO gas on surface profile and magnetic properties of Fe–Si–B amorphous ribbons

Influence of Fabrication Process on Magnetic Properties of Co-Finemet Nanocrystalline Powder Core

Effect of Co addition on catalytic activity of FePCCu amorphous alloy for methylene blue degradation

Degradation efficiency of Mg65Cu25−xAgxY10 nanoporous dealloyed ribbons on pesticide wastewater

Efficient degradation capability of the FePCB amorphous alloy in acid orange 7 dye solution

Nanostructured metallic glass contributing to efficient catalytic degradation of dye wastewater

Study of dielectric and magnetic properties with Fe76Si19.4Nb2.7Cu1.7P0.2 ribbons

Near-field electrospinning of PTFE/ZnO membrane with regular pore geometry and its photocatalytic performance