Effect of copper doping in the TiO2 film electrodes on the performance of photoelectrochemical biofuel cells

Dehui Li,Han Zheng,Fuyuan Zhang,Yang Zhao,Yanping Miao,Jing Yang

DOI: https://doi.org/10.1007/s13738-024-02972-5

2024-02-20

Journal of the Iranian Chemical Society

Abstract:Cu-doped TiO 2 film electrodes are synthesized via sol–gel technique and physically characterized. The Cu-doped TiO 2 film electrodes is sensitized by tetrakis (4-carboxyphenyl) porphyrin and applied as a photoanode of a photoelectrochemical biofuel cell (PEBFC). The Cu/TiO 2 -based PEBFCs show a short-circuit current (I sc ) of 75.9 μA, an open-circuit potential (V oc ) of 912 mV, a maximum power density (P max ) of 66.43 μW/cm 2 and an overall energy conversion efficiency (η) of 2.16%, respectively. The PEBFCs indicate improved photoelectric performances comparing the TiO 2 -based PEBFC (I sc : 72.5 μA, V oc : 740 mV, P max : 35.34 μW/cm 2 , η: 1.52%). The Cu/TiO 2 -based PEBFCs also indicate a higher incident photon-to-collected electron conversion efficiency (IPCE), which is probably due that the doped copper reduces the band gap of a wide-gap TiO 2 semiconductor as shown by ab initio band calculation. And the Cu/TiO 2 -based PEBFC can provide long electron lifetime and decrease electron–hole pair recombination rate, which is responsible for the better performance in the Cu/TiO 2 -based PEBFC than in the TiO 2 -based PEBFC.

chemistry, multidisciplinary