Abstract:A continuous worldwide increase in scandium (Sc) criticality leads to a quest for secondary scandium resources. Among them, bauxite residue (BR) - a waste product from alumina refineries - often contains substantial amounts of scandium. However, the complexity in BR composition drives the need for developing a selective, efficient and cost-effective process to achieve the separation and purification of scandium. Insoluble salts of tetravalent metal ions are inorganic, acid-resistant ion exchangers with well-established preparation procedures, but their potential use in rare-earth recovery and purification has not been extensively explored yet. Zirconium and titanium phosphates, both in amorphous and a-layered crystalline forms, were screened for Sc(III)/Fe(III) separation, as Fe(111) is one of the base elements in BR that is the most challenging to separate from Scalp. The studied alpha-zirconium phosphate (alpha-ZrP, Zr(HPO4)(2)center dot H2O) exhibited the highest Sc(III)/Fe(III) separation factors (up to approximately 23) from HCl solutions. The metal selectivity of alpha-ZrP was considered to be affected by the solution pH, and the size and hydration enthalpy of the metal cations. Breakthrough curves for a binary Sc(III)/ Fe(III) solution, composed of metal concentrations realistic to a typical BR leachate, revealed the selectivity of alpha-ZrP for Sc(III). Furthermore, chromatographic separation of Sc(In) from a real HCl leachate of BR was successfully achieved on an alpha-ZrP column. After a two-step elution with HCl about 60% of Sc(III) was collected in fractions without measurable Fe(III), Al(III) or other rare-earth impurities. Overall, this study highlights the possibility for direct and simplified separation of Sc(UI) from a much higher concentration of Fe(III) in BR, without the need of using reducing agents.

Assessing the Efficiency of Ion Exchange Resins for the Recovery of Scandium from Sulfuric Acid Leaching Solutions

Removal of Impurities from Scandium Solutions by Ion Exchange

Selective Recovery of Scandium (Sc) from Sulfate Solution of Bauxite Residue Leaching Using Puromet МТS9580 Ion-Exchange Sorption

Efficient and Selective Recovery of Trace Scandium by Inorganic Titanium Phosphate Ion-Exchangers from Leachates of Waste Bauxite Residue

Selective Scandium Elution from D2EHPA-Impregnated Ion-Exchange Resin After Metal Loading from Acidic Chloride Solutions

Extraction of scandium from scandium-rich material derived from bauxite ore residues

Selective Ion-Exchange Separation of Scandium(iii) over Iron(iii) by Crystalline Α-Zirconium Phosphate Platelets under Acidic Conditions

Recovery of scandium from white waste acid generated from the titanium sulphate process using solvent extraction with TRPO

Solvent Extraction of Scandium from Leaching Solution of Red Mud Roasted with Ammonium Sulfate Using D2EHPA/TBP

Direct Phosphoric Acid Leaching of Bauxite Residue for Selective Scandium Extraction

Efficient Extraction and Separation of Scandium from Scandium-Bearing Solid Waste and Acid by Synergistically Leaching Followed by Solvent Extraction

The Stepwise Extraction Strategy for Selective Recovery of Scandium from Hydrochloric Acid Leachate of Bauxite Residue Based on Reactivity of Metal Ions

Extraction of Scandium from Critical Elements-Bearing Mining Waste: Silica Gel Avoiding in Leaching Reaction of Bauxite Residue

Recovery of Scandium from Reservoir Silt by Electrical Separation

Recycling utilization of scandium from hydrolyzed sulfuric acid of titanium dioxide production

Separation and Recovery of Iron and Scandium from Acid Leaching Solution of Red Mud Using D201 Resin

Purifying Scandium Chloride Solution by Ion Exchange

A Critical Review on Separation and Extraction of Scandium from Industrial Wastes: Methods, Difficulties, and Mechanism

Scandium Recovery from Ion-Adsorption Rare Earth Concentrate with HEHEHP As Extractant

Advancing Selective Extraction: A Novel Approach for Scandium, Thorium, and Uranium Ion Capture

Selective recovery of vanadium and scandium by ion exchange with D201 and solvent extraction using P507 from hydrochloric acid leaching solution of red mud