Abstract:Abstract. The influence of fiber reinforcement with steel anchor fiber on the shrinkage of modified concrete for rigid airfield pavements repair has been determined. A 2-factor experiment was carried out, in which the following composition factors were varied: the amount of hardening accelerator Sika Rapid 3 from 0 to 2.4% of the cement content (0-9.6 kg/m3); the amount of steel anchor fiber with 1 mm diameter and 50 mm length, from 0 to 100 kg/m3. For the concrete batching were used: Portland cement CEM II / AS 42.5 in the amount of 400 kg/m3, granite crushed stone 5-20 mm, quartz sand, plasticizer admixture BASF MasterGlenium SKY 608 in the amount of 1.2% by cement content. The workability of the mixtures was S2 (6-8 cm); W/C ratio depended on the concrete composition. Due to the use of superplasticizers, the W/C of all investigated mixtures was in the range of 0.309-0.343. The shrinkage of the prism specimens was recorded after 3 hours, 6 hours, 1, 2, 3 and 7 days of being in air-dry conditions. The shrinkage process does not end after 7 days of concrete hardening, however, the general nature of the influence of variable factors on its value remains. It has been established that fiber-reinforced concretes, with a fiber amount of 50 kg/m3 and with a fiber amount of 100 kg/m3, have 10-15% less shrinkage compared to unreinforced concretes. Compositions with a fiber amount of 50 kg/m3 and 100 kg/m3 have practically the same shrinkage, which is explained by an increase in W/C ratio with an increase in the amount of fiber reinforcement. The amount of hardening accelerator has a less noticeable effect on the amount of concrete shrinkage. By adding Sika Rapid 3, concrete shrinkage at the age of 7 days is reduced by 2-9%. This effect can be explained by the fact that internal stresses arising in the process of structure formation and moisture loss in concrete are contained in a more durable cement-sand matrix. The concrete shrinkage without fiber and accelerator was also measured up to the age of 98 days. It was found that the limiting shrinkage for such concrete is 2.5×10-4. The analysis of the drawn experimental-statistical model showed that with the amount of metal fiber from 60 to 90 kg/m3 and the amount of the hardening accelerator from 0.9 to 2.4%, the shrinkage of the investigated concretes is minimal (7 = 1.3×10-4). Thus, the use of fiber reinforcement with anchor steel fiber and a hardening accelerator can significantly reduce the concrete shrinkage for the rigid airfield pavements repair is important for this material.

Modification of conditions and properties of dispersed reinforcing fiber during construction and operation of asphalt concrete pavements

Characteristics of Damaged Asphalt Mixtures in Tension and Compression

Performance of Fiber Reinforced Asphalt Concrete under Environmental Temperature and Water Effects

Modification and Enhancing Contribution of Fiber to Asphalt Binders and Their Corresponding Mixtures: A Study of Viscoelastic Properties

COMPARISON OF FIBER CONCRETE PROPERTIES FOR INDUSTRIAL FLOORS AND ROAD PAVEMENTS WITH STEEL AND POLYPROPYLENE FIBER

Experimental study of fibers in stabilizing and reinforcing asphalt binder

Durability of Frp Concrete Bonds and Its Constituent Properties under the Influence of Moisture Conditions

Water Stability of Fibers-Enhanced Asphalt Mixtures under Static and Dynamic Damage Conditions

Performance improvement of asphalt concretes using fiber reinforcement

Reinforcement Effect of Different Fibers on Asphalt Mastic

Evaluation and Design of Fiber-Reinforced Asphalt Mixtures

Research of Strength, Frost Resistance, Abrasion Resistance and Shrinkage of Steel Fiber Concrete for Rigid Highways and Airfields Pavement Repair

STRENGTH, ABRASION RESISTANCE AND FROST RESISTANCE OF FIBER CONCRETE OF HARD PAVEMENT WITH BASALT FIBER AND AIR-ENTRAINING ADMIXTURE

INFLUENCE OF FIBER REINFORCEMENT ON CONCRETE SHRINKAGE FOR RIGID ROAD AND AIRFIELD PAVEMENT REPAIR

Strengthening of High Plastic Clays by Geotextile Reinforcement

Theoretical modelling of the effect of thermal delamination of an asphalt concrete pavement from a rigid foundation of a road or bridge

Reinforcement of Silty Soil via Regenerated Fiber Polymer: A Study on Microscopic Mechanisms

Performance of Glass Wool Fibers in Asphalt Concrete Mixtures

Unraveling the influence of fibers on aging susceptibility and performance of high content polymer modified asphalt mixtures

Mechanistic Study on the Optimization of Asphalt-Based Material Properties by Physicochemical Interaction and Synergistic Modification of Molecular Structure

Substantiation of the distribution law and statistical characteristics of the fiber filaments length for reinforcing asphalt concrete mixture