Abstract:The issue of the safety of cotton seeds during the roller ginning process is one of the subjects of research on the dynamic processes of primary processing of raw materials. The study of the work of roller gins first of all showed that the process of roller ginning is based on the interaction of raw cotton, a working roller, a knife, and a breaking organ. This is a component that ensures, at certain interaction, the separation of fiber from the seeds. At the same time, there are probably no physical foundations that could determine the spatial orientation of these four components of the ginning process. In the process of roller ginning in the initial position, the seed is drawn to the slot of the contact gap of the knife-drum due to the tension of the fibers in the contact. Subsequently, the seed is struck with a certain impulse. The separation of the fibers from the seed after the impact of the beater occurs sequentially, not simultaneously. As a result of theoretical and experimental studies, the optimum frequency of shock pulse on the seed (f=18−20) was found to be the most technologically successful in terms of providing the best quality indicators of seeds and fibers. Beating in the resonance mode allows reducing the magnitude of the shock impulse on the seed leading to the reducing degree of damage to the seeds. It is believed that in the initial position, the seeds are drawn to the slit of the contact gap of the knife-drum machine due to the tension of the fibers in the contact. At this moment, the seeds at the end of the strand move only under the action of an elastic restoring force. The active part of the fiber bundle section in a dynamic process can be as little as 0.001 or less. The average value of the compliance coefficient for the raw cotton variety BA-440 was determined experimentally. This allows determining the stiffness coefficient of the volatiles indirectly. According to the obtained parameters, the dynamic state of the system practically falls into the region of parametric resonance, where the motion is unstable. This means that the seeds at the end of the strand increase significantly after the impact of the beater, which leads to the separation of the seeds from the fibers

Investigation of seeds mechanical extraction through the seed-removing device from saw gin

Study of fiber detachment dynamics from the seeds by the baffle element

Effect parameters of vertically spindle cotton picker machines on the mechanical damage of cotton seeds during machine harvesting

Research and creation of working organs of the tomato seed separator device

Determining optimal technological modes for pressing oil from melon seeds to justify rational engineering and structural solutions

INVESTIGATION OF CONTROLLED PARAMETERS OF THE SEEDING APPARATUS OF AN ELECTRIFIED SEEDER

DESIGN AND FABRICATION OF AN EXTRACTION MACHINE FOR TOMATO SEEDS

Theoretical substantiation of the parameters of the debris removal device of the cotton picker apparatus

Friction force determination between the inclined piles of the cotton gin drum from small impurities and seed of the fiber

Experimental Studies of the Seed-Sowing Device for the Grain Seeder SUBM-3.6

Results of theoretical and experimental researches about determination the corn seed separator sieve parameters of the corn-thresher machine

The separation of light impurities of safflower seeds in the cyclone of the grain cleaning machine

Design and Performance Evaluation of Canola-Seed Cleaning Machine

Design And Experiment of Axial Air-Suction Drum Seed-Metering Device

On the issue of increasing the efficiency of the spindles of a vertical-spindle cotton picker

Studying the design and operational parameters of the sieve module of the grain cleaning machine

Seeding Performance Simulations and Experiments for a Spoon-Wheel Type Precision Cottonseed-Metering Device Based on EDEM

UTILIZATION OF MILLING MACHINE FOR SEPARATING GRASS SEEDS FROM ALFALFA SEEDS

Design and Experimental Analysis of a Stirring Device for a Pneumatic Precision Rice Seed Metering Device

DESIGN AND CONSTRUCTION OF A FLAX RUBBING DESEEDER

Investigation of working bodies of cotton cleaning machine