Abstract:In the structure of the product's production, feed is in the first place and accounts for 60-70% of the total cost. The effectiveness of stagnation of concentrated feed depends on the quality of their preparation, and the uniformity of detail and type of fractional stock of animal husbandry products. In the midst of all the development of methods of refinement and design solutions for the greatest expansion for the refinement of feed grain, hammer mills have emerged, which, unlike any other in the world, provide energy saving, with fine grinding up to 40% of the saw-like fraction, and for coarse grains - up to 20% of whole and incomplete grains. At the same time, disk-type grain trimming designs are becoming more and more widespread in the world. Such structures are developed from hammer construction with lower energy consumption and higher yield of the finished product. Therefore, further research aimed at improving the efficiency of the work of disk workers is relevant. Experimental studies of disk grain processing were carried out based on the theoretical design of the experiment, which was why mathematical models of processes were selected in the form of regression. The factors in the experiment were the frequency of disk wrapping n (x1), the modular gap between the disks m (x2) and the moisture content of the grain W (x3). Optimization criteria are the energy density of the detail q (y1) and the uniformity of k (y2). The energy intensity of the process began as a balance between effort and productivity. Uniformity began as a relationship instead of often with rational parameters to the point of importance and was expressed in hundreds. As a result of experimental studies of disk grain processing, it has been established that the energy intensity of the process and the uniformity of the grain are dependent on all relevant factors, with which rational indicators are based on optimization criteria and do not match. The main task is to find the optimal variation of factors for two criteria, which makes it possible to confirm that the minimum energy intensity of the process is in the range q = 3.67...4.54 kWhour/t, one Particularity - k=86.5...92.6% at values of additional factors n=1260-1320 min-1; W=12.8-13.2% for a rational range of refinement steps.

Studying the design and operational parameters of the sieve module of the grain cleaning machine

Justification of the design and regime parameters of a mobile grain dryer

Design and Assessment of a Small-Scale Machine for Cleaning Wheat Grains

THE MAIN TRENDS IN THE DEVELOPMENT OF GRAIN CLEANING EQUIPMENT

Designing the structure and determining the mode characteristics of the grain dryer based on thermosiphons

MATHEMATICAL MODELING AND STUDY OF THE GRAIN CLEANING MACHINE SIEVE FRAME OPERATION

INFLUENCE OF THE COMPOSITION OF COLLECTED GRAIN HEAP ON THE EFFICIENCY OF ITS SEPARATION ON A GRID SURFACE

Design and Development of a Double-layer Grain Sieving Machine

Improving the efficiency of air-grid grain-separators for cleaning sunflower seeds

Design and Fabrication of Soyabean Screening Machine

Results of theoretical and experimental researches about determination the corn seed separator sieve parameters of the corn-thresher machine

Production Tests of a Grain-Cleaning Machine with Software and Hardware Control as Part of a Technological Line

Design and Performance Evaluation of Canola-Seed Cleaning Machine

EXPERIMENTAL DEVELOPMENT OF DISC GRAIN MILL

Research into the perforated surface of the double staged grinder-crusher

Mathematical modeling of the grain material separation in the pneumatic system of the grain-cleaning machine

IMPACT OF DRUM ROTATION FREQUENCY OF SEPARATING GRAIN THROWER ON GRAIN CLEANING EFFICIENCY

Design and Evaluation of Cyclone Separation Cleaning Devices Using a Conical Sieve for Rape Combine Harvesters

Justification choice parameters material input receiving and distributing device in the horizontal type air grain cleaning machine

Design, Fabrication and Performance Evaluation of Teff Cleaning Machine

FIELD STUDIES OF THE COULTER OF A GRAIN SEEDER WITH A HINGED CONNECTION OF A SEED GUIDE AND A RIPPER SOILS WITH BODY