Abstract:Purpose Titanium and its alloys are widely used as biomaterials for long-term implants, but they are usually surface-modified due to their weak bioactivity and wear resistance. Laser processing was used to modify the surface layer, and elemental carbon was a component of the deposited coatings. This research aims to use a combination of both methods based on preliminary electrophoretic deposition of multi-wall carbon nanotubes (MWNCTs) followed by pulse laser treatment. Carbon nanotubes were chosen due to their mechanical and chemical stability as well as their tubular shape, resulting in enhanced mechanical properties of laser-modified layers. Methods The pulse laser power and laser scanning speed were defined as variable process parameters. The microstructure, roughness Ra, nanohardness H, Young`s modulus E, and indent depth values were measured, and the H/E, H3/E2, and relative changes of all these values in comparison to MWCNTs-coated and non-coated surfaces, were calculated. Results The obtained results show that the best mechanical properties of MWCNTs-coated and laser-treated specimens are obtained at a laser power of 900 W and laser feed of 6 mm/s. The observed relations can be explained considering processes occurring on the surface such as deposition of carbon nanotubes, melting and re-crystallization of the surface layer, formation and possible partial decomposition of titanium carbides, and associated changes in local chemical composition, phase composition, and a level of residual stresses beneath the surface. Conclusions The developed process can substitute the time and money-consuming carbonization of titanium and its alloys.

Effects of Pulsed Laser Irradiation on Commercially Pure Titanium: Mechanical Properties and Corrosion Resistance in a Salty Environment

Salt spray corrosion behavior and electrochemical performance of Al and Ti reinforced Ni60 coating by laser cladding

Enhancing the corrosion properties and microhardness of titanium alloy by laser surface remelting

Studies on Laser Shock Peening on Nanomechanical and Mechano-Chemical Properties of Titanium Alloy (Ti6Al4V)

Effects of Pulsed Current on the Microstructure and Properties of Laser Cladded TC17 Titanium Alloy

Mechanical Properties and Residual Stress Measurements of Grade IV Titanium and Ti-6Al-4V and Ti-13Nb-13Zr Titanium Alloys after Laser Treatment

Microstructure and Hardness of the Laser Surface Treated Titanium

Electrochemical Corrosion Behaviors Before and after Laser Polishing of Additive Manufactured TC4 Titanium Alloy

Formation of titanium carbide on the titanium surface using laser ablation in n-heptane and investigating its corrosion resistance

Laser Surface Modification Of Titanium Alloys - A Review

Improved corrosion and long‐term immersion behavior in 3.5 wt% NaCl solution of laser powder bed fusion produced Ti5Cu after heat treatment

Effect Of Pulsed Current On Mechanical And Anticorrosion Properties Of Laser Cladded Coating

Characterization of a Laser Surface-Treated Martensitic Stainless Steel

Corrosion behavior of laser powder bed fusion additive manufacturing produced TiNi alloy by micro-arc oxidation

Influence of Surface Nano-Structuring on Microstructure, Corrosion Behavior and Osteoblast Response of Commercially Pure Titanium Treated Through Ultrasonic Shot Peening

Microstructural Characterization of Pure Titanium Treated by Laser Surface Treatment under Different Processing Parameters

Laser surface modification of Ti--6Al--4V: wear and corrosion characterization in simulated biofluid

Laser peening induced mitigation of severe pitting corrosion in titanium stabilized 321 steel

Effects of titanium nitride coatings on surface and corrosion characteristics of Ni-Ti alloy

Microstructure and Properties of Ti6Al4V Surface Processed by Continuous Wave Laser in Different Atmospheres

Effect of pulse laser treatment at different process variables on mechanical behavior of carbon nanotubes electrophoretically deposited on titanium alloy