Abstract:Arterial stiffness has been shown to be a good indicator of arterial wall disease. However, a single parameter is insufficient to describe the complex stress–strain relationship of a multi-component, non-linear tissue such as the aorta. We therefore propose a new approach to measure the stress–strain relationship locally in vivo noninvasively, and present a clinically relevant parameter describing the mechanical interaction between aortic wall constituents. The slope change of the circumferential stress–strain curve was hypothesized to be related to the contribution of elastin and collagen, and was defined as the transition strain (εθT). A two-parallel spring model was employed and three Young’s moduli were accordingly evaluated, i.e., corresponding to the: elastic lamellae (E1), elastin–collagen fibers (E2) and collagen fibers (E3). Our study was performed on normal and Angiotensin II (AngII)-treated mouse abdominal aortas using the aortic pressure after catheterization and the local aortic wall diameters change from a cross-correlation technique on the radio frequency (RF) ultrasound signal at 30MHz and frame rate of 8kHz. Using our technique, the transition strain and three Young’s moduli in both normal and pathological aortas were mapped in 2D. The slope change of the circumferential stress–strain curve was first observed in vivo under physiologic conditions. The transition strain was found at a lower strain level in the AngII-treated case, i.e., 0.029±0.006 for the normal and 0.012±0.004 for the AngII-treated aortas. E1, E2 and E3 were equal to 69.7±18.6, 214.5±65.8 and 144.8±55.2kPa for the normal aortas, and 222.1±114.8, 775.0±586.4 and 552.9±519.1kPa for the AngII-treated aortas, respectively. This is because of the alteration of structures and content of the wall constituents, the degradation of elastic lamella and collagen formation due to AngII treatment. While such values illustrate the alteration of structure and content of the wall constituents related to AngII treatment, limitations regarding physical assumptions (isotropic, linear elastic) should be kept in mind. The transition strain, however, was shown to be a pressure independent parameter that can be clinically relevant and noninvasively measured using ultrasound-based motion estimation techniques. In conclusion, our novel methodology can assess the stress–strain relationship of the aortic wall locally in vivo and quantify important parameters for the detection and characterization of vascular disease.

Using averaged models from 4D ultrasound strain imaging allows to significantly differentiate local wall strains in calcified regions of abdominal aortic aneurysms

Strain Patterns With Ultrasound for Assessment of Abdominal Aortic Aneurysm Vessel Wall Biomechanics

Strain patterns with ultrasound for improved assessment of abdominal aortic aneurysm vessel wall biomechanics

Regional Stiffness and Hardening Indices: New Indicators Derived from Multidimensional Dynamic CTA for Aneurysm Risk Assessment

In vivo bistatic dual-aperture ultrasound imaging and elastography of the abdominal aorta

Towards Full Automation of Geometry Extraction for Biomechanical Analysis of Abdominal Aortic Aneurysm; Neural Network-Based versus Classical Methodologies

Theoretical Modeling for Monitoring the Growth of Fusiform Abdominal Aortic Aneurysms Using Dielectric Elastomer Capacitive Sensors

Kinematics of Abdominal Aortic Aneurysms

Local Morphologic and Hemodynamic Analyses for the Prediction of Abdominal Aortic Aneurysm Rupture Based on Patient-Specific CTA and Computational Modeling

Automated quantitative 3D analysis of aorta size, morphology, and mural calcification distributions

In Vivo Quantification of Ascending Thoracic Aortic Aneurysm Wall Stretch Using MRI: Relationship to Repair Threshold Diameter and Ex Vivo Wall Failure Behavior

In vivo characterization of the aortic wall stress-strain relationship.

The Impact of a Limited Field-of-View on Computed Hemodynamics in Abdominal Aortic Aneurysms: Evaluating the Feasibility of Completing Ultrasound Segmentations with Parametric Geometries

Numerical Simulation for the Impact of Various Abdominal Aortic Aneurysms Models

A Cohort Longitudinal Study Identifies Morphology and Hemodynamics Predictors of Abdominal Aortic Aneurysm Growth

On the feasibility of ultrasound Doppler-based personalized hemodynamic modeling of the abdominal aorta

Comparison of In-Vivo and Ex-Vivo Ascending Aorta Elastic Properties through Automatic Deep Learning Segmentation of Cine-MRI and Biomechanical Testing

Influence of wall compliance on hemodynamics in models of abdominal aortic aneurysm

Three-dimensional thoracic aorta principal strain analysis from routine ECG-gated computerized tomography: feasibility in patients undergoing transcatheter aortic valve replacement

Characterization of the Stress-Strain Relationship of the Abdominal Aortic Wall in Vivo.

Characterization of small abdominal aortic aneurysms' growth status using spatial pattern analysis of aneurismal hemodynamics