Abstract:This paper presents a laboratory study on electrokinetic dewatering (EKD) of sewage sludge with fixed and moving electrodes. The experiments with fixed electrodes were conducted in two purposely designed Perspex cylinders to investigate the mechanism of attenuation in electroosmotic flow and dewatering efficiency. The experiments with moving electrodes were performed in an innovatively designed apparatus, in which the anode made of an array of stainless rods can be moved toward the fixed cathode plate. The fixed-electrode experiments showed that the electrical resistance of the dewatered section near the anode increased with the treating time, and hence the voltage gradient left for the undewatered section decreased. The increased electrical resistance resulted in an increase in the invalid energy consumption, and the reduced voltage gradient at the undewatered section resulted in an attenuation in electroosmotic flow and dewatering effect. Comparison tests conducted with the moving-anode apparatus further demonstrated the attenuation mechanism. Only a slight attenuation in the electroosmotic flow was observed in the moving-anode experiments, in which the anode array was moved to pass by the dewatered section and keep the voltage gradient on the undewatered section unchanged. As compared with the fixed-electrode experiments, the dewatering effect for the moving-anode experiments was much better, and the energy consumption in terms of removed water volume was significantly lower. When the moving-anode method was applied with a voltage gradient of 8 V/cm and an initial electrode spacing of 1 cm, the sludge with a water content of 82.1% can be dewatered to 62.2%, and the estimated energy consumption is as low as 18 kWh . m(-3). The research findings shine a light on the use of the moving-electrode method for improving the treatment efficiency of EKD. (C) 2015 American Society of Civil Engineers.

Classification of battery slurry by flow signal processing via echo state network model

Data-driven analysis of temporal evolution of battery slurry in pipe systems

Malfunction Diagnosis in Horizontal Stirred Bed Reactors Based on Attractor Comparison Analysis of Acoustic Emission Signals

Electrokinetic Dewatering of Sewage Sludge with Fixed and Moving Electrodes: Attenuation Mechanism and Improvement Approach

Agglomeration detection in horizontal stirred bed reactor based on autoregression model by acoustic emission signals

Rapid prediction of flow and concentration fields in solid-liquid suspensions of slurry electrolysis tanks

Experimental and Computational Analysis of Slurry-Based Manufacturing of Solid-State Battery Composite Cathode

Online Sequential Extreme Learning Machine Based Adaptive Control for Wastewater Treatment Plant

Soft Sensor Model for Dredging Discharge Pipeline Slurry Concentration Measurement Based on Radial Basis Function Neural Network

Direct observation of carbon slurry flow behavior and its effect on electrochemical performance in a microfluidic electrochemical flow capacitor

A novel method for identifying aerobic granular sludge state using sorting, densification and clarification dynamics during the settling process

Structural Analysis of Cathode Slurry Under Flow Using New Probe for Rheo-Impedance Measurements

Semi-supervised echo state network with temporal–spatial graph regularization for dynamic soft sensor modeling of industrial processes

Embedded Continuous Casting Slag Detection System Based on Artificial Neural Network

Soft-sensing of Wastewater Treatment Process Via Deep Belief Network with Event-triggered Learning.

Laboratroy Study on Electrokinetic Dewatering of Sewage Sludge

Investigations on Using Intelligent Learning Techniques for Anomaly Detection and Diagnosis in Sensors Signals in Li-Ion Battery—Case Study

Classification of flow regimes using a neural network and a non-invasive ultrasonic sensor in an S-shaped pipeline-riser system

A methodology for sequencing batch reactor identification with artificial neural networks: A case study

In situ porosity intelligent classification of selective laser melting based on coaxial monitoring and image processing

Identification of Gas/solid Two-Phase Flow Regimes Using Electrostatic Sensors and Neural-Network Techniques