Abstract:In this study, the basalt fiber content (0%, 0.075%, and 0.15%) and replacement ratio of recycled coarse aggregate (0%, 50%, and 100%) were used as parameters, and the compressive strength of 15 cubes and 15 prisms was analyzed. The failure morphology of the specimens was characterized, and the cubic compressive strength, axial compressive strength, elastic modulus, Poisson's ratio, and other mechanical property indices of the specimens were measured. Upon increasing the replacement ratio, the degree of damage of the specimens gradually increased, whereas the cubic compressive strength, axial compressive strength, and elastic modulus gradually decreased. As the replacement ratio was increased from 50% to 100%, the cubic compressive strength and elastic modulus were noted to decrease the most by about 9.07% and 9.87%, respectively. On the other hand, the Poisson's ratio first decreased, followed by an increase. Upon increasing the fiber content, the degree of damage of the specimens was gradually reduced, whereas the cubic compressive strength, axial compressive strength, and elastic modulus gradually increased. As the fiber content increased from 0.075% to 0.15%, the axial compressive strength and elastic modulus increased the most by about 6.65% and 10.19%, respectively. On the other hand, the Poisson's ratio gradually decreased. Based on the test data, the functional relationships between the strength indices and different variables, as well as the conversion value of each strength index and different variables were established; after comparison and verification, the formula calculation results were found to be in good agreement with the test results. The microstructural changes in the basalt fiber reinforced recycled aggregate concrete were characterized by scanning electron microscopy (SEM), and the changes in the mechanical properties of the basalt fiber reinforced recycled aggregate concrete as well as the mechanism of fiber modification and reinforcement were explained from a micro perspective.

Mechanical properties of short polypropylene fiber enhanced recycled concrete under cyclic compression

Test Research on the Influencing Factors of the Mechanical Property of the Polypropylene Fiber Recycled Concrete

High-strain Rate Compressive and Tensile Behavior of Concrete with Substituted Polyamide Sand

Intensified Test Research on the Influence of Polypropylene Fiber & Silica Fume on Recycled Concrete

High-strain Rate Compressive Behavior of Concrete with Two Different Substituted Recycled Plastic Aggregates: Experimental Characterization and Probabilistic Modeling

Behavior of FRP-Confined Recycled Brick Aggregate Concrete under Monotonic Compression

Mechanical Properties of Fully Recycled Aggregate Concrete Reinforced with Steel Fiber and Polypropylene Fiber

Experimental Study on Mechanical Performance and Microstructure of Polypropylene Fiber Recycled Concrete

Study on mechanical properties and microcosmic morphology of polypropylene fiber reinforced recycled concrete after freeze–thaw cycles

A Study of Energy Dissipation of Polypropylene Fiber Reinforced Recycled Concrete Under Uniaxial Compression

Mechanical Properties and Durability of Polypropylene and Steel Fiber-Reinforced Recycled Aggregates Concrete (FRRAC): A Review

Experimental Investigation on the Mechanical Properties of Polypropylene Hybrid Fiber-Reinforced Roller-Compacted Concrete Pavements

Mechanical properties and failure modes of polypropylene fiber-reinforced foamed concrete subjected to high strain rates and large compressive deformation: effects of fiber content and length

Compressive Behavior, Microstructural Properties, and Freeze–Thaw Behavior of Tailing Recycled Aggregate Concrete with Waste Polypropylene Fiber Addition

Mechanical performance of steel-polypropylene hybrid fiber reinforced concrete subject to uniaxial constant-amplitude cyclic compression: Fatigue behavior and unified fatigue equation

Dynamic compressive behaviors of polyethylene terephthalate fiber reinforced recycled aggregate concrete

Effects of air-entraining agent and polypropylene fiber on the mechanical properties, autogenous shrinkage, and fracture properties of fully recycled aggregate concrete

Mechanical Properties of Polypropylene Fiber Recycled Brick Aggregate Concrete and Its Influencing Factors by Gray Correlation Analysis

Mechanical Properties under Compression and Microscopy Analysis of Basalt Fiber Reinforced Recycled Aggregate Concrete

Flexural fatigue performance and damage evolution analysis of multiscale polypropylene fiber‐reinforced concrete

Research on Compressive Impact Dynamic Behavior and Constitutive Model of Polypropylene Fiber Reinforced Concrete