Abstract:The effects of oil type, emulsifier type, and emulsion particle size on the texture, gel strength, and rheological properties of SPI emulsion-filled gel (SPI-FG) and TFSP emulsion-filled gel (TFSP-FG) were investigated. Using soybean protein isolate or sodium caseinate as emulsifiers, emulsions with cocoa butter replacer (CBR), palm oil (PO), virgin coconut oil (VCO), and canola oil (CO) as oil phases were prepared. These emulsions were filled into SPI and TFSP gel substrates to prepare emulsion-filled gels. Results that the hardness and gel strength of both gels increased with increasing emulsion content when CBR was used as the emulsion oil phase. However, when the other three liquid oils were used as the oil phase, the hardness and gel strength of TFSP-FG decreased with the increasing of emulsion content, but those of SPI-FG increased when SPI was used as emulsifier. Additionally, the hardness and gel strength of both TFSP-FG and SPI-FG increased with the decreasing of mean particle size of emulsions. Rheological measurements were consistent with textural measurements and found that compared with SC, TFSP-FG, and SPI-FG showed higher G' values when SPI was used as emulsifier. Confocal laser scanning microscopy (CLSM) observation showed that the distribution and stability of emulsion droplets in TFSP-FG and SPI-FG were influenced by the oil type, emulsifier type and emulsion particle size. SPI-stabilized emulsion behaved as active fillers in SPI-FG reinforcing the gel matrix; however, the gel matrix of TFSP-FG still had many void pores when SPI-stabilized emulsion was involved. In conclusion, compared to SPI-FG, the emulsion filler effect that could reinforce gel networks became weaker in TFSP-FG.

Effect of Flaxseed Gum on the Textural, Rheological, and Tribological Properties of Acid-Induced Soy Protein Isolate Gels

The effect of addition of flaxseed gum on the emulsion properties of soybean protein isolate (SPI)

Effect of flaxseed gum on the rheological properties of peanut protein isolate dispersions and gels

Effect of Sesbania Gum on the Rheological, Textural, and Microstructural Characteristics of CaSO4-induced Soy Protein Isolate Gels

Rheological and Microstructural Characteristics of Thermally Produced Flaxseed Gum–Whey Protein Isolate Mixed Solutions and Gels

Effects of Flaxseed Gum Concentrations and Ph Values on the Stability of Oil-In-Water Emulsions

Characterization of Non-Linear Rheological Behavior of Spi-Fg Dispersions Using Laos Tests and Ft Rheology

Rheological Properties of Soy Protein Isolate – Carboxymethyl Flaxseed Gum Mixed Dispersions under Large Amplitude Oscillatory Shear

Influence of soybean dietary fiber with varying particle sizes and transglutaminase on soy protein isolate gel

Effect of three soluble dietary fibers on the properties of flaxseed gum-based hydrogels: A comparison study and mechanism illustration

Effects of Xanthan Gum on the Rheological Properties of Soy Protein Dispersion

Stabilization of Soybean Oil by Flaxseed Gum and NMR Characterization of Its Oil–water Interface

Effect of flaxseed gum on the brittleness of oleogels based on candelilla wax

Effect of Gums on the Rheological Characteristics and Microstructure of Acid-Induced SPI-gum Mixed Gels.

Effect of Concentrated Flaxseed Protein on the Stability and Rheological Properties of Soybean Oil-in-water Emulsions

Influence of Various Levels of Flaxseed Gum Addition on the Water-Holding Capacities of Heat-Induced Porcine Myofibrillar Protein

Improvement of the rheological and textural properties of calcium sulfate-induced soy protein isolate gels by the incorporation of different polysaccharides

Effect and Mechanism of Acid-Induced Soy Protein Isolate Gels As Influenced by Cellulose Nanocrystals and Microcrystalline Cellulose

Impact of flaxseed gum on the aggregate structure, pasting properties, and rheological behavior of waxy rice starch

Investigating the effects of oil type, emulsifier type, and emulsion particle size on textured fibril soy protein emulsion-filled gels and soybean protein isolate emulsion-filled gels

Physical and Rheological Properties of Mixed-Component Emulsion-Based Products: Influence of Flaxseed Gum Concentration and Ph on the Aggregation of Lipid Droplets