Abstract:For energy efficient ventilation and low carbon design, solar chimney has been extensively applied on buildings. In the present work, three representative solar chimneys were introduced, i.e., Model 1 with top-horizontal outlet, Model 2 with upper-vertical outlet and Model 3 with middle-vertical outlet. Updraft ventilation from the built enclosure to the outlet and heat transfer from the absorber to the fluid by heat convection were numerically and theoretically investigated, and their limitations and correlations with governing parameters were also discussed. Streamlines and heatlines were used to visualize transport paths of air and heat respectively. Reverse flow could not be observed in the solar chimney channels of Model 2 and Model 3; Therefore, total volume flow rate induced by the solar chimneys Model 2 and Model 3 and convection heat transfer rate of the absorber increases positively with thermal Rayleigh numbers ( Ra ). Model 2 chimney produces greater thermal buoyancy than that by Model 3, and its air flow rate is higher than that of Model 3. Generally, volume flow rate induced in Model 1 is higher than those of Model 2 and Model 3 as Ra is no more than 2.5 × 10 6 , and simultaneously, convection heat transfer rate Nusselt number ( Nu ) is also greater than those of Model 2 and Model 3. When Ra exceeded 2.5 × 10 6 , reverse air flow was intensified further, Nu of Model 1 started to decline. The three models with discrete heat sources could induce more air from indoor than that respective model without discrete heat sources. The maximum increment rate is obtained by the Model 1 solar chimney with discrete heat sources, then Model 2 and the least done by Model 3. Their power relationships between Nu and Ra , V*and Ra are regressed respectively. The dependence of volume flow rate on broad thermal Rayleigh numbers covering all the three flow regimes showed that there were linear correlations between discrete numerical volume flow rates and the scaling predictions, except in Model 1 for high Ra (exceeding critical value 9.0 × 10 5 ), where volume flow rate was remarkably reduced due to reverse air flow. This research could provide useful theoretical information for applying small sized vertical solar chimneys attached to the building sidewall to effectively reduce built energy consumption.

Optimization of characteristic parameters of rectangular solar chimney adapted to agricultural greenhouses

Numerical Investigation and Multi‐objective Thermo‐economic Optimization of a Solar Chimney Power Plant

Experimental and Numerical Studies of Solar Chimney for Ventilation in Low Energy

Experimental and Numerical Studies for Applying Hybrid Solar Chimney and Photovoltaic System to the Solar-Assisted Air Cleaning System

Determining the influencing factors on the performance of solar chimney in buildings

Experimental and Numerical Studies of Solar Chimney for Ventilation in Low Energy Buildings

Numerical and experimental study of laboratory and full-scale prototypes of the novel solar multi-surface air collector with double-receiver tubes integrated into a greenhouse heating system

Structural optimization to reduce the environmental crosswind negative influence on the performance of a solar chimney power plant system

Numerical Study on the Performance of A Solar Chimney Power Plant

Efficiency improvement of the solar chimneys by insertion of hanging metallic tubes in the collector: Experiment and computational fluid dynamics simulation

Numerical Analysis of the Optimal Turbine Pressure Drop Ratio in A Solar Chimney Power Plant

A combined wall and roof solar chimney in one building

Simulation of a sloped solar chimney power plant in Lanzhou

Experimental Investigations and Numerical Analysis of Solar Chimney for Building Ventilation

An application of artificial neural network (ANN) for comparative performance assessment of solar chimney (SC) plant for green energy production

Investigating the Influence of Absorber Plate Geometry on Solar Chimney Performance

Performance Study of a Dual-Function Roof Solar Collector for Chinese Traditional Buildings Application

Solar chimney for a real building considering both energy-saving and fire safety – a case study

Study on Optimizing Design of Solar Chimney for Natural Ventilation and Smoke Exhaustion

The Energetic, Exergetic, and Mechanical Comparison of Two Structurally Optimized Non-Concentrating Solar Collectors for Intermediate Temperature Applications

Heat removal and ventilation limitations of the solar chimney attached with a built enclosure: Correlations of thermal Rayleigh numbers, port arrangements and discrete heating elements