Abstract:A continuous-rate digital clock and data recovery (CDR) with automatic frequency acquisition is presented. The proposed automatic frequency acquisition scheme implemented using a conventional bangbang phase detector (BBPD) requires minimum additional hardware, is immune to input data transition density, and is applicable to subrate CDRs. A ring-oscillator-based two-stage fractional-N phase-locked loop (PLL) is used as a digitally controlled oscillator (DCO) to achieve wide frequency range, low noise, and to decouple the tradeoff between jitter transfer (JTRAN) bandwidth and ring oscillator noise suppression in conventional CDRs. The CDR is implemented using a digital D/PLL architecture to decouple JTRAN bandwidth from jitter tolerance (JTOL) corner frequency, eliminate jitter peaking, and remove JTRAN dependence on BBPD gain. Fabricated in a 65 nm CMOS process, the prototype CDR achieves error-free operation (BER ${\rm{<10^{-12}}}$) from 4 to 10.5Gb/s with pseudorandom binary sequence (PRBS) data sequences ranging from PRBS7 to PRBS31. The proposed automatic frequency acquisition scheme always locks the CDR loop within 1000 ppm residual frequency error in worst case. At 10Gb/s, the CDR consumes 22.5${\rm{\,mW}}$ power and achieves a recovered clock long-term jitter of 2.2 ${\rm ps_{rms}}$/24.0 ${\rm{ ps_{pp}}}$ with PRBS31 input data. The measured JTRAN bandwidth and JTOL corner frequencies are 0.2 and 9MHz, respectively.

Low-complexity robust baud-rate clock recovery for probabilistically shaped Nyquist signals in short-reach coherent transmission systems

Multiplication-free and hardware-efficient baud-rate timing error detector for Nyquist and faster than Nyquist optical IM/DD systems

Time-domain low-complexity clock recovery for non-integer oversampled Nyquist signals with a small roll-off factor

WR-enhanced TDM-PON with nanosecond clock and data recovery and picosecond time synchronization

All-Optical, Bit-Rate Tunable Clock Recovery For Nrz-Ask Signals

Sub-Nyquist Sampled Analog-to-Digital Conversion Based on Photonic Time Stretch and Compressive Sensing with Optical Random Mixing

Optoelectrical Clock Recovery with Dispersion Monitoring for High Speed Transmission

Low hardware-complexity IQ skew tolerant finite field and time domain hybrid adaptive equalization for 400G/800G-ZR coherent transmission

Probabilistic Shaping-Assisted Bit-Energy Efficient THz Photonic Wireless Transmission

Low-complexity two-stage carrier phase recovery using principal component reconstruction analysis and optimal decision maximum likelihood for PS-MQAM systems

Low timing jitter 40 Gb/s all-optical clock recovery based on an amplified feedback laser diode

DACNN-aided nonlinear equalizer for a probabilistic shaping coherent optical communication system

Low-timing-jitter all-optical clock recovery for 40 Gbits/s RZ-DPSK and NRZ-DPSK signals using a passively mode-locked quantum-dot Fabry-Perot semiconductor laser

Low-Phase-Noise Clock Recovery from NRZ Signal and Simultaneous NRZ-to-RZ Format Conversion

Flexible Coherent Communication System With Adaptable SNR and Laser Phase Noise Tolerance for Probabilistically Shaped QAM

A Low-latency Multi-format Carrier Phase Recovery Hardware for Coherent Optical Communication

Carrier Phase Recovery Friendly Probabilistic Shaping Scheme Based on a Quasi-Maxwell-boltzmann Distribution Model.

Probabilistic shaping for ROF system with heterodyne coherent detection

A One-bit quantized low-sampling-rate timing recovery algorithm based on cyclic correlation preservation for millimeter wave communication

Power-aided probabilistic shaping parameter optimization for long-haul optical fiber transmission

A 4-to-10.5 Gb/s Continuous-Rate Digital Clock and Data Recovery With Automatic Frequency Acquisition