Abstract:Currently, emphasis is placed on using environmentally friendly materials both from a structural point of view and the application of protective means. For this reason, it is advisable to deal with the thermal modification of wood, which does not require the application of protective substances, to increase its service life. The main reason for the thermal modification of black locust is that although black locust grows abundantly in our country, it has no industrial use. It is mainly used outdoors, where thermal modification could increase its resistance. This article deals with the thermal modification of black locust wood (Robinia pseudoacacia L.) and the impact of this modification on the chemical components of the wood with an overlap in the change in mechanical properties compared to untreated wood. Static (LOP, MOR, and MOE) and dynamic (IBS) bending properties were evaluated as representative mechanical properties. At the same time, the impact of thermal modification on the representation of chemical components of wood (cellulose, lignin, hemicellulose) was also tested. As a result of the heat treatment, the mechanical properties gradually decreased as the temperature increased. The highest decrease in mechanical values found at 210 °C was 43.7% for LOP and 45.1% for MOR. Thermal modification caused a decrease in the content of wood polysaccharides (the decrease in hemicelluloses content was 33.2% and the drop in cellulose was about 29.9% in samples treated at 210 °C), but the relative amount of lignin in the wood subjected to increased temperature was higher due to autocondensation, and mainly because of polysaccharide loss. Based on the correlations between chemical and mechanical changes caused by thermal modification, it is possible to observe the effects of reducing the proportions of chemical components and changes in their characteristic properties (DP, TCI) on the reduction in mechanical properties. The results of this research serve to better understand the behavior of black locust wood during thermal modification, which can primarily be used to increase its application use.

Analysis of chemical properties of thermally treated Pinus roxburghii Sargent wood

Comparison of physical and mechanical properties of Paulownia tomentosa and Pinus koraiensis wood heat-treated in oil and air

Changes of Phenolics, Condensed Tannins and Antioxidant Activity of Chinese Hickory (Carya cathayensis Sarg.) after Different Thermal Processing

Impact of thermal modification on color and chemical changes of spruce and oak wood

Effect of Thermal Modification on the Nano-Mechanical Properties of the Wood Cell Wall and Waterborne Polyacrylic Coating

Effect of thermal treatment with water, H2SO4 and NaOH aqueous solution on color, cell wall and chemical structure of poplar wood

Effect of Thermal Treatment on the Chemical, Physical, and Mechanical Properties of Pedunculate Oak (Quercus robur L.) Wood

Comparison of the chemical and micromechanical properties of Larix spp. after eco-friendly heat treatments measured by in situ nanoindentation

Color as an Indicator of Properties in Thermally Modified Scots Pine Sapwood

Effects of thermal treatment on the mechanical properties of larch (Larix gmelinii) and red oak (Quercus rubra) wood cell walls via nanoindentation

Effects of different heat treatment media on odorous constituents, chemical decomposition and mechanical properties of two hardwoods

Mechanical properties of industrial heat-treated wood

Effect of extractives on wood color of heat treated Pinus radiata and Eucalyptus pellita

Structural Characterization of Steam-Heat Treated Tectona Grandis Wood Analyzed by FT-IR and 2D-IR Correlation Spectroscopy

How thermal treatment affects the chemical composition and the physical, mechanical and swelling properties of Scots pine juvenile and mature wood

Effects of thermal treatment on air-dried density, color change, average surface roughness, and sound absorption capacity of Scots pine

Structural Changes of Oak Wood Main Components Caused by Thermal Modification

Thermogravimetric Analysis of Pinus Wood For Kinetic Analysis by Using Coats and Redfern Method

Degradation of Chemical Components of Thermally Modified Robinia pseudoacacia L. Wood and Its Effect on the Change in Mechanical Properties

Extractive composition and summative chemical analysis of thermally treated eucalypt wood