Abstract:Increasing cuttings bed height is a serious concern during extended-reach well drilling. In order to predict and prevent cuttings bed height increase, it is essential to study how the critical parameters influence the cuttings transport, especially the drill pipe rotation effects on the cuttings transport process. In conventional models for cuttings transport, the dynamic behavior of particles due to drill pipe rotation is neglected or empirically simplified. This paper presents a coupled Computational Fluid Dynamics and Discrete Element Method (CFD–DEM) approach to simulate the cuttings transport considering the dynamic collision process. The fluid phase is treated as an Eulerian continuum and described by CFD method. The cutting phase is modeled by DEM using a soft sphere approach for the particle collision dynamic. The continuum and dispersed phases are strongly coupled via the interaction forces such as the drag force, lift force and pressure gradient force, which is taken into account in the developed CFD–DEM model. The model takes into account the collisions of cutting–cutting, cutting–drill pipe and cutting–wall. Simulations are carried out for a number of laboratory-scale configurations, showing good agreement with experiment data reported in literature. The numerical simulations show that the drill pipe rotation builds cuttings presented in non-symmetric distribution along the hole and significantly decreases the cutting volume concentration at the medium and high fluid inlet velocities and lower range of drill pipe speeds. There is no additional contribution of drill pipe rotation after reaching a critical speed at high fluid inlet velocities. At low fluid inlet velocities, increasing the drill pipe rotation from 0 to 80rpm dose not significantly affect the cuttings concentration; although an increase in drill pipe rotation speed from 100 to 120rpm provided a remarkable improvement. Furthermore, at low inlet fluid velocities and horizontal inclinations up to 40°, drill pipe rotation can significantly decrease the cuttings concentration. The effect of drill pipe rotation on decreasing the cuttings concentration is almost negligible at high inlet fluid velocities for any inclination.

Rheological effects of air drilling fluids on cuttings transportation in underbalanced drilling

AADE-20-FTCE-SPP-08 CFD Approach to Investigate the Effect of Mud Rheology on Cuttings Removal in Horizontal Wells

Experimental investigation and CFD simulation of multiphase flow behavior in air reverse circulation drilling

Numerical simulation of transport behaviour of small cuttings in extended reach wells

A Numerical Simulation of the Effect of Drilling Fluid Rheology on Cutting Migration in Horizontal Wells at Different Drilling Fluid Temperatures

Investigation: Cutting Transport Mechanism in Inclined Well Section under Pulsed Drilling Fluid Action

Application of Computational Fluid Dynamics for Investigation the Effect of the Hole Cleaning Parameters in Inclined and Horizontal Wells

Oil-Based Drilling Fluid's Cuttings Bed Removal Properties for Deviated Wellbores

Study of Cleaning the Horizontal Drains during the Under Balanced Drilling Well in the South Algeria Fields

Sensitivity Analysis of Major Drilling Parameters on Cuttings Transport during Drilling Highly-inclined Wells

Numerical Investigations on the Effect of a Cuttings Bed Remover on the Cuttings Carrying Capacity in Horizontal Drilling

Numerical investigation of flow patterns in cuttings transport for extended-reach horizontal wells with rotation drillpipe

Effect of Yield Power Law Fluid Rheological Properties on Cuttings Transport in Eccentric Horizontal Narrow Annulus

Fully Coupled CFD–DEM Simulation of Oil Well Hole Cleaning: Effect of Mud Hydrodynamics on Cuttings Transport

Insight into dust control performance of a reverse circulation drill bit using multiphase flow simulation

CFD–DEM approach to investigate the effect of drill pipe rotation on cuttings transport behavior

Experimental Investigation of the Rheological Behavior of an Oil-Based Drilling Fluid with Rheology Modifier and Oil Wetter Additives

Transportation of cuttings through drill rods during reverse-circulation reaming

Prediction of Cuttings-Induced Annular-Pressure Loss in Extended-Reach Wells

A CFD Validation Effect of YP/PV from Laboratory-Formulated SBMDIF for Productive Transport Load to the Surface

Interaction between Pipe Rotation and Cuttings Transport in Extended-Reach Drilling: Mechanism, Model, and Applications