Abstract:This study extended the strength criterion used to determine the failure of a soil structure from a differential expression at a point or an infinitesimal element to an integral expression along a global consecutive slip surface. In addition, a local failure criterion that described the limit equilibrium state of each area of a sliding surface inside a soil mass was established. Accordingly, it was unnecessary to make any assumptions regarding the sliding surface, along which the soil mass reached its equilibrium state. An arbitrary shape could be investigated without any restrictions, as long as its algorithm followed the above theoretical unification. Along the corresponding surface, the integral of the shear stress equal to that of the shear strength was proven to be a sufficient and necessary condition. Based on this sufficient and necessary condition, a safety factor for soil sliding stability was defined. It indicates the mean value of either the shear strength reduction factor or the overloading coefficient alone the surface, both of which make the soil mass above the surface reach the equilibrium state along the surface. This proposed safety factor could be used not only to evaluate the overall state of soil structural stability but also its local failures. In addition, the gradual development of failure process could be analyzed. Two examples were presented, involving the studies on stepwise formation of slip curves inside a slope and foundation. These demonstrated that the significantly improved method presented in this paper could effectively be applied to an analysis of the progressive failure process of a geotechnical structure.

Criterion of shear failure along a surface inside soil-mass and its application to progressive failure analysis

Slope Failure Criteria of Shear Strength Reduction Finite Element Method

Analytical calculation of the critical inclination of rock slopes with a planar failure surface under water pressure

Reliability analysis of progressive failure of strain softening slope

Deduction and Verification of A New Strength Criterion for Soils

Elastoplastic strain localization analysis of soil slope

Identification of arbitrarily shaped critical 3D failure surface of a slope based on the sliding direction

Study of the Failure Mechanism and Progressive Failure Process of Intact Rock Patches of Rock Slope with Weak Surfaces

Stability analysis of slope in strain-softening soils using local arc-length solution scheme

Study of Failure Criterion for Hangzhou Intact Soft Clay under Complex Stress Path

An Anisotropic Failure Criterion for Cross-anisotropic Soils

Numerical Modeling of Failure Process of Soil Slopes

Development of an SPH-based method to simulate the progressive failure of cohesive soil slope

The evaluation for dynamic safety coefficient of rock slope under seismic loading

Estimating the critical shear stress for incipient particle motion of a cohesive soil slope

Study of shear properties and shear model of soil-rock mixture

A Generalized Nonlinear Failure Criterion for Frictional Materials

Stability analysis of cut slope with shear band propagation along a weak layer

Amendment of the twin-shear criterion and its application to calculation of earth pressure

Study on Shear Strength of Expansive Soil Considered Softening and Slope Stability Analysis with FLAC(3D)

Behaviour and Mechanism of Failure Process of Soil Slopes