Abstract:Under supercritical conditions, the effects of the microporous zeolite-coated macroporous supports (i.e., ceramic-supported ZSM-5 catalysts and metal-supported ZSM-5 catalysts) on the endothermic pyrolysis process of methylcyclohexane (MCH, CH 3 C 6 H 11 ) were examined. The micro-macroporous composite materials were characterized using X-ray diffraction (XRD), scanning electron microscopy (SEM), energy-dispersive X-ray spectroscopy (EDS), and NH 3 temperature-programmed desorption (NH 3 -TPD) analysis. ZSM-5-coated Al 2 O 3 hollow fiber and ZSM-5-coated NiCrFeAl metal foam were both tested using an isothermal constant-pressure continuous-flow heterogeneous catalytic reactor at high temperature (550 °C) and pressure (50 bar) that simulate supersonic jet engines. The MCH pyrolysis conversions and post-pyrolysis products were determined by gas chromatography, while the deposited coke on the microporous zeolite catalysts was quantified using thermogravimetric (TG) analysis. ZSM-5-coated NiCrFeAl metal foam catalyst showed a slightly higher MCH pyrolysis conversion (%) than ZSM-5-coated Al 2 O 3 hollow fiber catalyst. On the other hand, the ZSM-5-coated Al 2 O 3 hollow fiber produces fewer aromatic hydrocarbons (benzene, toluene, and xylene, BTX), as well as cyclic or polycyclic hydrocarbons (naphthalene). Additionally, the coke deposition was approximately 2 times lower on the ZSM-5-coated Al 2 O 3 hollow fiber catalyst compared to the ZSM-5-coated NiCrFeAl metal foam. Furthermore, due to the endothermic nature of the catalytic pyrolysis of MCH under supercritical jet conditions over the studied microporous zeolite-coated macroporous supports, a temperature decrease of approximately 15–20 °C was observed.

Comparison of catalytic efficiency of MCM-41/metal and metal powder catalysts in Crambe orientalis pyrolysis

Catalytic effect of metal powder and MCM‐41/metal catalysts on the pyrolysis of cellulose

Pyrolysis of Crambe Orientalis Plant in the Presence of Metal Supported MCM-41 Catalyst: The Effect of Catalyst Ratio on Liquid Product Composition

Investigation of the effect of metal powder and metal-supported MCM-41 catalysts on the pyrolysis of horse chestnut fruits and shells (Aesculus hippocastanum L.)

Comparative Study on Molybdenum Nitride, Phosphide and Carbide

[Influence of ZSM-5(38)/Al-MCM-41 Composite Molecular Sieve Catalysts on Pyrolysis of Cellulose].

Impact of microporous zeolite-coated macroporous supports on the catalytic pyrolysis of methylcyclohexane under supercritical conditions

Impact of Pt/Al-MCM-41 Catalyst Metal/Acid Ratio in Hydrocracking of Bio-Alkanes for Bio-Jet Fuel Production

Catalytic Co-Pyrolysis of Cellulose and Polypropylene over All-Silica Mesoporous Catalyst MCM-41 and Al-MCM-41.

Study on the Pyrolysis of Cellulose for Bio-Oil with Mesoporous Molecular Sieve Catalysts.

Experimental Study of Polyethylene Pyrolysis and Combustion over HZSM-5, HUSY, and MCM-41.

Catalytic performance of Co, Fe on MCM-41 synthesized from illite waste for gasification of torrefied cassava rhizome

Preparation of Metal-Modified Carbon-Based Catalyst and Experimental Study on Catalytic Pyrolysis of Distillers Dried Grains with Solubles

Catalyst Evaluation for Catalytic Biomass Pyrolysis

Production of MAH-Rich Bio-Oil from Co-Pyrolysis of Biomass and Plastics Using Carbonized MOF Catalysts under Microwave Irradiation

Effect of Catalytic Pyrolysis Conditions Using Pulse Current Heating Method on Pyrolysis Products of Wood Biomass

The utilization of novel NaF/Al2O3 catalysts in the process of hydrothermal liquefaction of Crambe orientalis: synthesis and characterization

Bio-MCM-41: a high-performance catalyst support derived from pyrolytic biochar

Study on lightening of coal tar with metal oxide supported γ-Al2O3 catalyst

Catalytic pyrolysis of biomass: Effects of pyrolysis temperature, sweeping gas flow rate and MgO catalyst

Synergistic Effects of Catalyst Mixtures on Biomass Catalytic Pyrolysis