Energy-saving CO2 capture using sulfolane-regulated biphasic solvent

Rujie Wang,Lei Jiang,Qiangwei Li,Ge Gao,Shihan Zhang,Lidong Wang
DOI: https://doi.org/10.1016/j.energy.2020.118667
IF: 9
2020-11-01
Energy
Abstract:<p>Because of phase separation characteristics, biphasic solvents are recognized as promising absorbents for CO<sub>2</sub> capture with low regeneration heat consumption. However, limited CO<sub>2</sub> loading in CO<sub>2</sub>-rich phase, associated with excessive CO<sub>2</sub>-rich phase volume, challenges the energy-saving regeneration potential of mixed-amine biphasic solvents. In this study, sulfolane was employed as a phase splitter to improve the phase separation properties of N,N-diethylenetriamine (DETA)-N,N,N′,N″,N″-pentamethyldiethylenetriamine (PMDETA) biphasic absorbent. By introducing the hydrophobic sulfolane, large CO<sub>2</sub> capacity (increased from 3.56 to 6.48 mol/L) and low CO<sub>2</sub>-rich phase volume (decreased from 100% to 27.1%) were simultaneously achieved. Moreover, sulfolane acted as an absorption accelerator to increase the CO<sub>2</sub> absorption rate in DETA-PMDETA-sulfolane solvent to 1.3 times the corresponding DETA-PMDETA solvent. Benefiting from the large CO<sub>2</sub> capacity associated with favorable phase separation behavior, DETA-PMDETA-sulfolane has a minimized regeneration heat estimated at 1.86 GJ/t-CO<sub>2</sub> at a lean CO<sub>2</sub>-loading of 0.55 mol/mol. This is 53.4% lower than the regeneration heat (3.99 GJ/t-CO<sub>2</sub>) using 5 M monoethanolamine solvent.</p>
energy & fuels,thermodynamics
What problem does this paper attempt to address?