Abstract:To address the problems of the relatively high energy penalty and corrosivity of aqueous biphasic solvents, a novel nonaqueous biphasic solvent composed of 2-((2-aminoethyl)amino)ethanol (AEEA), dimethyl sulfoxide (DMSO), and N,N,N′,N″,N″-pentamethyldiethylenetriamine (PMDETA) was proposed for CO2 capture. With optimization, this novel AEEA–DMSO–PMDETA (A–D–P) biphasic solvent could achieve a high CO2 loading of 1.75 mol·mol–1, of which 96.8% of the absorbed CO2 was enriched in the lower phase with only 49.6% of the total volume. 13C NMR analysis and quantum calculations revealed that A–D–P could absorb CO2 to form not only carbamate but also carbamic acid species, which were stabilized by DMSO via hydrogen-bonding interactions. Most products were highly polar and preferred to dissolve in polar DMSO rather than the less polar PMDETA, thus leading to the phase change. The thermodynamics results showed that the heat duty of A–D–P was only 1.66 GJ·ton–1 CO2 (393.15 K), which was significantly lower than that of the benchmark MEA (3.59 GJ·ton–1 CO2) and the reported aqueous biphasic solvents. Moreover, A–D–P presented a noncorrosive behavior to steel after CO2 saturation, clearly showing its superiority over MEA and the aqueous biphasic solvents. Therefore, with superior properties of energy savings and noncorrosiveness, the A–D–P biphasic solvent could be a promising candidate for CO2 capture.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acs.est.0c05774?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acs.est.0c05774</a>.Additional details on the experimental procedure, calculation method of parameters, schematic diagrams of experimental apparatuses, absorption and desorption data, schematic diagram of the reaction mechanism, VLE data, and parameter data for calculating regeneration heat (<a class="ext-link" href="/doi/suppl/10.1021/acs.est.0c05774/suppl_file/es0c05774_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

CO 2 Absorption Using Biphasic Solvent: Blends of Diethylenetriamine, Sulfolane, and Water

A Water-Lean Triazole Ionic Liquid Biphasic Solvent for Energy-Efficient CO2 Capture Through Reversible Polarity and Intermolecular Hydrogen Bonding

Experimental Study on CO2 Absorption in Novel Biphasic Solvents and CO2 Desorption by Novel Direct Non-Aqueous Gas Stripping Process

Novel Nonaqueous Liquid–Liquid Biphasic Solvent for Energy-Efficient Carbon Dioxide Capture with Low Corrosivity

CO2 Absorption by Novel Biphasic Solvents: Blends of BDA, DGM, and Water

Carbon Dioxide Absorption in Aqueous Alkanolamine Blends for Biphasic Solvents Screening and Evaluation

Energy-saving CO2 capture using sulfolane-regulated biphasic solvent

Experimental and theoretical investigation of an ionic liquid-based biphasic solvent for post-combustion CO 2 Capture: Breaking through the "Trade-off" effect of viscosity and loading

Energy-efficient carbon dioxide capture using a novel low-viscous secondary amine-based nonaqueous biphasic solvent: Performance, mechanism, and thermodynamics

Energy-efficient non-aqueous biphasic solvent for carbon capture: Absorption mechanism, phase evolution process, and non-corrosiveness

Sulfolane-based Biphasic Solvent with High Water-Balance Robustness and Degradation Resistance for Industrial CO2 Capture

Research on alkanolamine based physical-chemical solutions as biphasic solvents for CO2 capture

Dynamic phase-splitting behaviour of biphasic solvent for carbon capture in a novel annular phase separator

Research of Novel Polyamine-Based Biphasic Absorbents for CO2 Capture Using Alkanolamine to Regulate the Viscosity and Mechanism Analysis

Research of novel polyamine-based biphasic absorbents for CO 2 capture using alkanolamine to regulate the viscosity and mechanism analysis

Novel alkanolamine-based biphasic solvent for CO 2 capture with low energy consumption and phase change mechanism analysis

Liquid–Solid Phase‐Change Behavior of Diethylenetriamine in Nonaqueous Systems for Carbon Dioxide Absorption

Experimental study on CO2 capture using 2‐(2‐aminoethylamino)ethanol/N,N‐diethyl‐ethanolamine/sulfolane phase‐change absorbents

Novel 2-amino-2-methyl-1-propanol-based biphasic solvent for energy-efficient carbon dioxide capture using tetraethylenepentamine as a phase change regulator

Integration of Physical Solution and Ionic Liquid Toward Efficient Phase Splitting for Energy-Saving Co2 Capture

Energy-Efficient Biphasic Solvents for Industrial Carbon Capture: Role of Physical Solvents on CO2 Absorption and Phase Splitting.