Comprehensive recovery of arsenic and antimony from arsenic-rich copper smelter dust

Jianrong Xue,Dongping Long,Hong Zhong,Shuai Wang,Lihua Liu

DOI: https://doi.org/10.1016/j.jhazmat.2021.125365

IF: 13.6

2021-07-01

Journal of Hazardous Materials

Abstract:<p>In view of reducing contaminant and recovery arsenic and antimony, a novel technology was proposed to recover arsenic and antimony from arsenic-rich copper smelter dust comprehensively. The technique route includes three stages: arsenic and antimony trioxides were leached from the copper smelter dust with hydrochloric acid; trivalent arsenic ions (As³⁺) were then reduced to less toxic simple arsenic (As) by sodium hypophosphate (NaH₂PO₂) and recovered; and stepwise recovery of antimony by SbCl₃ was achieved by the continuous distillation technique. The results indicates that the leaching efficiency of As and Sb was over 97.5% and 96.8% under conditions of initial 4.0 mol/L HCl, liquid-solid ratio (L/S) of 6:1, leaching temperature of 363 K and time of 2 h. Over 92.5% arsenic was recovered by NaH₂PO₂ reduction under the suitable conditions: 363 K, 1.5 h and 2.0 times addition of NaH₂PO₂. The recovery rate of Sb is more than 97.53% at 393 K. The distillation temperature of SbCl₃ was optimized between 463 K and 473 K. The corresponding mechanisms of the leaching and recovering of arsenic and antimony were systematically investigated and confirmed by E-pH diagram, thermodynamic calculation, arsenic speciation, composition analysis and XRD characterization.</p>

environmental sciences,engineering, environmental

What problem does this paper attempt to address?

This paper aims to solve the comprehensive recovery problems of arsenic and antimony in arsenic - containing copper dust generated during the copper smelting process. Specifically, the paper proposes a new technology for efficiently recovering arsenic and antimony from arsenic - rich copper smelting dust, in order to reduce the environmental pollution caused by these harmful substances and realize the effective utilization of resources. The technical route includes three stages:

1. **Leaching stage**: Hydrochloric acid (HCl) is used to leach the trioxides of arsenic and antimony from the copper smelting dust.
2. **Reduction and recovery stage**: Sodium hypophosphite (NaH₂PO₂) is used to reduce trivalent arsenic ions (As³⁺) to less - toxic simple arsenic (As), thereby achieving the recovery of arsenic.
3. **Continuous distillation and recovery stage of antimony**: Antimony is gradually recovered in the form of SbCl₃ through continuous distillation technology.

The research results show that under the conditions of an initial HCl concentration of 4.0 mol/L, a liquid - to - solid ratio (L/S) of 6:1, a leaching temperature of 363 K and a time of 2 hours, the leaching efficiencies of arsenic and antimony are respectively more than 97.5% and 96.8%. Under appropriate conditions (363 K, 1.5 hours and 2.0 times the addition of NaH₂PO₂), more than 92.5% of arsenic is recovered through NaH₂PO₂ reduction. At 393 K, the recovery rate of antimony is more than 97.53%. The distillation temperature of SbCl₃ is optimized between 463 K and 473 K.

In addition, the paper also systematically studies the leaching and recovery mechanisms of arsenic and antimony, including E - pH diagrams, thermodynamic calculations, arsenic speciation analysis, component analysis and XRD characterization. These studies are helpful for in - depth understanding of the leaching and recovery processes of arsenic and antimony, and provide theoretical support for practical applications.