Advanced Characterization and Optimization of NiOx:Cu‐SAM Hole‐Transporting Bi‐Layer for 23.4% Efficient Monolithic Cu(In,Ga)Se2‐Perovskite Tandem Solar Cells

Ivona Kafedjiska,Igal Levine,Artem Musiienko,Natalia Maticiuc,Tobias Bertram,Amran Al‐Ashouri,Christian A. Kaufmann,Steve Albrecht,Rutger Schlatmann,Iver Lauermann

DOI: https://doi.org/10.1002/adfm.202302924

IF: 19

2023-05-27

Advanced Functional Materials

Abstract:Monolithic Cu(In,Ga)Se2 (CIGSe)‐perovskite tandem solar cells (23.4%‐efficient) manufactured on CIGSe absorbers with a non‐negligible surface roughness is demonstrated. Conformal coverage of the bottom sub‐cell, shunt prevention and high effective lifetime in the top cell, and fast hole extraction, favorable band alignment, and suppressed electron trapping at the HTL‐perovskite interface are achieved by using copper‐doped nickel oxide NiOx:Cu + [2‐(3,‐6Dimethoxy‐9H‐carbazol‐9yl)ethyl]phosphonic acid (MeO‐2PACz) as a hole‐transporting bi‐layer. The performance of five hole‐transporting layers (HTLs) is investigated in both single‐junction perovskite and Cu(In, Ga)Se2 (CIGSe)‐perovskite tandem solar cells: nickel oxide (NiOx,), copper‐doped nickel oxide (NiOx:Cu), NiOx+SAM, NiOx:Cu+SAM, and SAM, where SAM is the [2‐(3,‐6Dimethoxy‐9H‐carbazol‐9yl)ethyl]phosphonic acid (MeO‐2PACz) self‐assembled monolayer. The performance of the devices is correlated to the charge‐carrier dynamics at the HTL/perovskite interface and the limiting factors of these HTLs are analyzed by performing time‐resolved and absolute photoluminescence ((Tr)PL), transient surface photovoltage (tr‐SPV), and X‐ray/UV photoemission spectroscopy (XPS/UPS) measurements on indium tin oxide (ITO)/HTL/perovskite and CIGSe/HTL/perovskite stacks. A high quasi‐Fermi level splitting to open‐circuit (QFLS‐Voc) deficit is detected for the NiOx‐based devices, attributed to electron trapping and poor hole extraction at the NiOx‐perovskite interface and a low carrier effective lifetime in the bulk of the perovskite. Simultaneously, doping the NiOx with 2% Cu and passivating its surface with MeO‐2PACz suppresses the electron trapping, enhances the holes extraction, reduces the non‐radiative interfacial recombination, and improves the band alignment. Due to this superior interfacial charge‐carrier dynamics, NiOx:Cu+SAM is found to be the most suitable HTL for the monolithic CIGSe‐perovskite tandem devices, enabling a power‐conversion efficiency (PCE) of 23.4%, Voc of 1.72V, and a fill factor (FF) of 71%, while the remaining four HTLs suffer from prominent Voc and FF losses.

materials science, multidisciplinary,chemistry, physical,physics, applied, condensed matter,nanoscience & nanotechnology