Abstract:The increasing scarcity of natural sands has led to a growing preference for manufactured sand in the production of construction materials in response to sustainable development. However, existing research typically applies it to ordinary concrete, its application in advanced concrete still remains relatively limited to date. In this study, manufactured sand was used as aggregate to prepare the eco-friendly ultra-high performance concrete (UHPC). To further improve the effectiveness of solid waste management and alleviate its impact on the environment, the feasibility of ecological utilization of recycling stone powder (SP), a by-product from manufactured sand industry, as partial substitutes for cementitious materials was explored. The fresh and hardened properties, microstructural characteristics, environmental and economic implications were evaluated. Results indicated that the introduction of SP considerably enhanced the rheological properties and reduced the exothermic peak temperature of UHPC paste. With the increase of SP, a first increasing and then decreasing trend was seen in flowability. An equivalent or slightly improved level of mechanical strength was revealed at low SP content (i.e., 10%). Different lithological SP was found to enhance the toughness and suppress the early shrinkage of UHPC. Incorporating SP increased the total pore volume and refined the distribution of pore sizes, and could also change the morphology of hydration products and Si/Ca ratio of interfacial transition zone. Additionally, the lowest unit compressive strength costs were achieved at the substitution of 20%, 10% and 20% for granite, tuff and limestone mixtures, and the carbon emissions could be lowered by 26.9% compared with traditional UHPC when 30% of SP was involved, showing excellent economic and environmental benefits.

Influence of polyurethane in the polymerization process for poorly graded sand stabilization and cementing

The Effect of Polymer-Fiber Stabilization on the Unconfined Compressive Strength and Shear Strength of Sand

Experimental Study on Mechanical Behavior of Sand Improved by Polyurethane Foam

Effect of Polyurethane on the Stability of Sand–clay Mixtures

Experimental study on the effect of chitosan biopolymer on sandy soil stabilization

Improvement of Water Stability of Sand Admixed with Water-Soluble Organic Polymer

Combined Influences of Cement, Rice Husk Ash and Fibre on the Mechanical Characteristics of a Calcareous Sand

Influence of Polyurethane Polymer on the Strength and Mechanical Behavior of Sand-root Composite

Recycling Stone Powder As a Partial Substitute for Cementitious Materials into Eco-Friendly Manufactured Sand Ultra-High Performance Concretes: Towards Cleaner and More Cost-Effective Construction Production

Assessing the stabilization impact of silica fume and phosphogypsum on hydro-mechanical characteristics of clayey sand

Evaluating the Effect of Cement and ARG Fiber on the Mechanical and Microstructural Properties of Dune Sand

Synergistic effect of Polyvinyl Acetate (PVA) and Enzyme-Induced Carbonate Precipitation (EICP) on the mechanical properties of natural sands

Strength and Fracture Properties of Sandy Subgrade Soil Treated with Sodium Polystyrene Sulfonate

Experimental investigation and discrete element method simulation on mechanical properties and failure mechanism of polymer-stabilized sand

Strength for Modified Polyurethane with Modified Sand

Effect of hybrid type of fibers on the mechanical properties of stabilized sand with coal waste and cement

THE INFLUENCE OF SUPERPLASTICISERS ON THE FRESH AND MECHANICAL BEHAVIOUR OF FOAM CONCRETE UTILIZING POFA AS SAND REPLACEMENT

Mechanical Behavior of Cemented Sand Reinforced with Different Polymer Fibers

Effectiveness of a New Organic Polymer Sand-Fixing Agent on Sand Fixation

Experimental investigation of sandy soil stabilization using chitosan biopolymer

Shear behavior of polyurethane foam adhesive improved calcareous sand under large-scale triaxial test