Research on the tilt-to-length Coupling Noise Suppression Method inside the Gravitational Wave Detection Telescope
Wen Tong Fan,Jie Song,Hong Wen Hai,Si Jun Fang,Kai Zhao,Rui Zhang,Bo Hong Li,Jian Luo,Qi Cheng Sun,Lei Fan,Zi Zheng Li,Hsien-Chi Yeh,Yong Yan,WenTong Fan,HongWen Hai,Sijun Fang,Rui zhang,Bohong li,Qicheng Sun,Zizheng Li,Yong YAN
DOI: https://doi.org/10.1364/oe.512394
IF: 3.8
2024-01-08
Optics Express
Abstract:As an integral component of the laser interferometry measurement system, the tilt-to-length (TTL) coupling noise inside the telescope stands out as a critical noise factor that requires meticulous consideration. In the TianQin project, the non-geometric TTL-coupled noise inside the telescope should be less than 0.22 pm/Hz 1/2 . Additionally, the wavefront aberration RMS at the small pupil of the telescope needs to be better than 0.0065 λ. These requirements set for the telescope are exceptionally stringent. To address this challenge, this study aims to relax the wavefront aberration requirements by mitigating non-geometric TTL coupling noise, while ensuring the non-geometric TTL coupling noise remains below 0.22 pm/Hz 1/2 . By controlling the coupling aberration proportion, the wavefront aberration RMS at the small pupil of the telescope can be relaxed to 0.014 λ. Alternatively, optimizing the Gaussian beam waist radius can relax the wavefront aberration RMS to 0.016 λ. By simultaneously utilizing two optimization methods, the wavefront aberration at the small pupil of the telescope can be reduced to 0.033 λ, resulting in an impressive success rate of 91.15% in meeting the noise requirements.
optics