Abstract:This work introduces a new way to assess the condition of highways and classify them as congested or uncongested highways. This was done by recording a video and sorting the number of lane change orders instead of finding the traffic density, delay, and flow rate. Then extracting data from the video and performing a microscopic simulation for it to study the driver's behavior and create the statistical model. Thus, obtaining the mathematical relationships and coefficients that illustrate that process, after verifying the reliability and calibration of these variables. This research aims to facilitate the highway assessment process, as an alternative or supplementary method of highway evaluation by the Highway Capacity Manual 2010. It is adequate to record a video and count the number of vehicles that change their lanes and then compare them with the results that have been determined in the search to judge the highway is congested or not. The study area was achieved by choosing five segments of multilane arterial roads (six lanes divided) on the left coast of Mosul city. These segments were selected to be as similar as possible in the geometric configuration as well as like traffic flow. After that, cameras were installed according to criteria to record traffic movement and for a time not less than ten hours for each segment, and on the workdays for traffic movement. Then, the videos were uploaded using the Goodvision traffic data recognition program. These outputs were converted to be entered into the PTV-VISSIM traffic simulation program in addition to the other geometric information needed by the program to complete the analysis process and find traffic flow parameters. In the extraction process, the normal distribution and the uniform nature of the data representation of the observed event on the segments were examined using the Z-test and the K-S test, the results were normal and significant. Then the results were verified and the traffic parameters such as density and flow rate were checked to ensure the nature of the traffic flow. The process was also verified using the vehicle motion graphic representation method (Vehicle Trajectory), which is the initial examination to estimate the new variable. A new variable has been extracted, which is one of the traffic movement variables, which depends on the percentage of complete and proper lane change completion within the parameters imposed by the simulation program, it’s the Lane Change Occupancy factor (LnChOc.). Then the statistical model was derived using SPSS for the new variable. It describes traffic conditions on highways and the results are verified and calibrated in more than one way. It’s a simple statistical model was obtained to estimate the traffic movement from this variable and vice versa from the following equation:, Which gave results for critical traffic on multi-lane roads in the Mosul city as follows: - Ø Ø Ø

Evaluation of Capacity and Level of Service for Heterogeneous Traffic of Urban Multi-Lane Highways

The Quantitative Analysis of the Level of Service of Two-lane Highways Based on Overtaking Ratio

Analysis of Traffic Flow Characteristics under Large Volume in Highway Tunnel Group Region

Evaluating Stability and Performance in Mixed Traffic: A Theoretical and Co-Simulation Approach

Congestion Identification for Multilane Highway by Vehicle Lane Change as Driver Behavior

HIGHWAY CAPACITY MANUAL REVISIONS OF CHAPTERS 9 AND 11

Level of Service of Multi-Lane highway Section under fluctuated traffic flow condition: a state-dependent Discrete-Event Simulation framework

Two-Level Full Factorial Design Approach for the Analysis of Multi-Lane Highway Section under Saturated and Unsaturated Traffic Flow Conditions

Evaluation of level of service at few signalized intersections using Indian Highway Capacity Manual (Indo-HCM, 2018)

Determination of Level of Service and Traffic Flow Characteristics for a Selected Arterial Roads in Bangalore City

Modeling of urban road network traffic carrying capacity based on equivalent traffic flow

Evaluation Method for Bicycle Lane Level of Service Based on User Perception and Capacity Simulation

A PHD-DES Framework for the Performance Assessment of Multi-lane Highways Under Random Traffic Flow

Grey Clustering Assessment Of Level Of Service For Urban Expressway Segments

Analysis of Traffic Flow Performance and Capacity on Captain Ismail Street, Tegal City

Modeling Congestion on Urban Roads and Assessing Level of Service

Estimation of Capacity of Two-Lane Two-Way Highways Using Simulation Model

Diagnosis of road capacity and service level using the highway capacity manual

MTCS: A Method of Analyzing the Traffic Capacity of Urban Bus Lane Based on Vissim Simulation

Measuring Passenger Car Equivalents (PCE) for Heavy Vehicle on Two Lane Highway Segments Operating Under Various Traffic Conditions

Study on the Relationship between Urban Road Network Service Level and Capacity