Abstract:As the major power source for electric vehicles (EVs), lithium-ion batteries (LiBs) suffer from the degradation of technical performance and safety at low temperatures, which restricts the popularization of EVs in frigid regions. Thus, this study developed an extremely fast electromagnetic induction heating system in order to improve the poor performance of LiBs in cold weather. An electrochemical–thermal coupling model (ETCM), validated against the experimental results of charge and discharge, which successfully predicted LiB voltage, temperature, and other physical characteristics at various ambient temperatures, was established in COMSOL Multiphysics 6.0 as a development tool for evaluating the heating effect of the system. When the copper coil is subjected to a SAC (sinusoidal alternating current) of 8 A and 50 Hz, the LiB can be heated from 243.15 to 293.15 K within 6 min with an instantaneous temperature increase rate of 0.263 K/s and a homogeneous temperature distribution. The results of the capacity calibration, cyclable lithium detection, and HPPC simulation show that the heating method can visibly increase the Li+ concentration inside the active particle, and there was only a tiny concentration gradient on the surface of the particle. In addition, the internal resistance was approximately a quarter of that without heating; therefore, both the discharge energy and specific power boost were two times higher than the original level. Compared to the normal charge–discharge cycles at 293.15 K, the capacity retention of the LiB only decreased by 0.23% after 60 consecutive heating cycles, so the heating method can balance the temperature rise, work capacity, and LiB health. Furthermore, the improvements in the thermal insulation condition and material thermal conductivity are two feasible ways to optimize the temperature-increase effect.

Research on pulse charging current of lithium-ion batteries for electric vehicles in low-temperature environment

Review of Low-Temperature Performance, Modeling and Heating for Lithium-Ion Batteries

The Dilemma of C-Rate and Cycle Life for Lithium-Ion Batteries under Low Temperature Fast Charging

An ultra-fast charging strategy for lithium-ion battery at low temperature without lithium plating

Lithium-Ion Batteries under Low-Temperature Environment: Challenges and Prospects

A rapid self-heating strategy of lithium-ion battery at low temperatures based on bidirectional pulse current without external power

Temperature Distribution of Lithium Ion Battery Module with Inconsistent Cells under Pulsed Heating Method

Heating Lithium-Ion Batteries at Low Temperatures for Onboard Applications: Recent Progress, Challenges and Prospects

Temperature consistency–oriented rapid heating strategy combining pulsed operation and external thermal management for lithium-ion batteries

Targeting the low-temperature performance degradation of lithium-ion batteries: a non-destructive bidirectional pulse current heating framework

Pulse self-heating strategy for low-temperature batteries based on bidirectional charging systems

A Novel DC-AC Fast Charging Technology for Lithium-Ion Power Battery at Low-Temperatures

Experimental study on self-heating strategy of lithium-ion battery at low temperatures based on bidirectional pulse current

A Review on Low-Temperature Performance Management of Lithium-Ion Batteries

Frequency varying heating strategy for lithium-ion battery rapid preheating under subzero temperature considering the limitation of on-board current

High-Frequency AC Heating Strategy of Electric Vehicle Power Battery Pack in Low-Temperature Environment

Sensitivity Analysis on the Parameters of Lithium-Ion Battery DC Pulse Preheating under Low Temperature

Investigation of novel pulse preheating strategies for lithium-ion batteries at subzero temperature based on a multi-level CFD platform

Challenges and development of lithium-ion batteries for low temperature environments

Review of low‐temperature lithium‐ion battery progress: New battery system design imperative

Research on the Improvement of Lithium-Ion Battery Performance at Low Temperatures Based on Electromagnetic Induction Heating Technology