Abstract:As the major power source for electric vehicles (EVs), lithium-ion batteries (LiBs) suffer from the degradation of technical performance and safety at low temperatures, which restricts the popularization of EVs in frigid regions. Thus, this study developed an extremely fast electromagnetic induction heating system in order to improve the poor performance of LiBs in cold weather. An electrochemical–thermal coupling model (ETCM), validated against the experimental results of charge and discharge, which successfully predicted LiB voltage, temperature, and other physical characteristics at various ambient temperatures, was established in COMSOL Multiphysics 6.0 as a development tool for evaluating the heating effect of the system. When the copper coil is subjected to a SAC (sinusoidal alternating current) of 8 A and 50 Hz, the LiB can be heated from 243.15 to 293.15 K within 6 min with an instantaneous temperature increase rate of 0.263 K/s and a homogeneous temperature distribution. The results of the capacity calibration, cyclable lithium detection, and HPPC simulation show that the heating method can visibly increase the Li+ concentration inside the active particle, and there was only a tiny concentration gradient on the surface of the particle. In addition, the internal resistance was approximately a quarter of that without heating; therefore, both the discharge energy and specific power boost were two times higher than the original level. Compared to the normal charge–discharge cycles at 293.15 K, the capacity retention of the LiB only decreased by 0.23% after 60 consecutive heating cycles, so the heating method can balance the temperature rise, work capacity, and LiB health. Furthermore, the improvements in the thermal insulation condition and material thermal conductivity are two feasible ways to optimize the temperature-increase effect.

Heating Lithium-Ion Batteries at Low Temperatures for Onboard Applications: Recent Progress, Challenges and Prospects

Heating Strategy for Electric Vehicular Battery Pack Based on CFD Analysis

Review of Low-Temperature Performance, Modeling and Heating for Lithium-Ion Batteries

Temperature consistency–oriented rapid heating strategy combining pulsed operation and external thermal management for lithium-ion batteries

Targeting the low-temperature performance degradation of lithium-ion batteries: a non-destructive bidirectional pulse current heating framework

Research on the Improvement of Lithium-Ion Battery Performance at Low Temperatures Based on Electromagnetic Induction Heating Technology

Research on low temperature internal AC heating device for lithium-ion battery

An optimized internal heating strategy based on bidirectional pulsed current for lithium-ion battery at low temperature

All-temperature area battery application mechanism, performance, and strategies

Review on preheating systems for Lithium-ion batteries of electric vehicles under low temperature circumstance

Temperature Distribution of Lithium Ion Battery Module with Inconsistent Cells under Pulsed Heating Method

Lithium-Ion Batteries under Low-Temperature Environment: Challenges and Prospects

Cell Design for Improving Low-Temperature Performance of Lithium-Ion Batteries for Electric Vehicles

A Review on Low-Temperature Performance Management of Lithium-Ion Batteries

A Rapid Self-Heating Battery Pack Achieved by Novel Driving Circuits of Electric Vehicle

Optimal external heating resistance enabling rapid compound self-heating for lithium-ion batteries at low temperatures

Design and Implementation of a Non-Destructive AC Heating System for Lithium-Ion Battery Modules

Research on pulse charging current of lithium-ion batteries for electric vehicles in low-temperature environment

Challenges and recent progress in thermal management with heat pipes for lithium-ion power batteries in electric vehicles

Challenges and development of lithium-ion batteries for low temperature environments

A review of Li‐ion battery temperature control and a key future perspective on cutting‐edge cooling methods for electrical vehicle applications