Abstract:Torsional vortex-induced vibrations (VIVs) pose potential risks to prototype bridges with increasing spans and lower damping levels. However, the underlying mechanism remains unclear. Wind tunnel tests revealed that torsional VIVs occurred at an initial attack angle of + 3°. To unravel the VIV mechanism throughout the lock-in range, encompassing the ascent stage, amplitude extremum, and descent stage, the spatio-temporal distribution of aerodynamic forces around the bridge girder was analyzed. The results demonstrated the presence of traveling pressure waves with approximately 2.5 wavelengths and three uniformly distributed separated vortices over the upper side throughout the lock-in range. The primary source of these travelling pressure waves stemmed from the vortex drift patterns, with the aerodynamic wave travelling velocity equating the vortex drift velocity. The formation of separated vortices, known as the "double-vortex model", occurred at the windward barrier on the upper side and windward maintenance rail on the lower side. These vortices directly imposed travelling pressure waves on the girder, thereby inducing torsional VIVs. Among them, the former vortices contributed more to the VIVs than the latter. Therefore, the formation of separated vortices and their related aerodynamic waves in the windward edge with the 2nd SVM/AWM modes predominantly governed the occurrence of torsional VIVs. Furthermore, both the ratio of the wave travelling time to the vibration period and the mean value of the wave travelling velocity ratio exhibited an inverse relationship with the VIV responses. However, the actions exerted by the vortex drift patterns were proportional to the VIV responses on both the upper and lower sides. Therefore, there existed evolutionary characteristics of aerodynamic waves and their related vortex drift patterns throughout the lock-in range, which was responsible for the "lock-in" phenomena.

Frequency Lock-In Phenomenon of Vortex Induced Vibration of a Rotating Blade Considering Bending-Torsion Coupling Effect

Numerical Simulation of Vortex Shedding and Lock-In Characteristics for A Thin Cambered Blade

Parametric Vibration and Combined Resonance of a Bending-Torsional Coupled Turbine Blade With a Preset Angle

Experimental and numerical investigations on non-synchronous vibration and frequency lock-in of transonic compressor rotor blades

Coupled Shaft-Torsion and Blade-Bending Vibrations of a Rotating Shaft–Disk–Blade Unit

Multi-mode of Vortex-Induced Vibration of a Flexible Circular Cylinder

Investigations on bifurcation behavior of wind turbine airfoil response at a high angle of attack

A numerical simulation of VIV on a flexible circular cylinder

The Torsional Vibration of Turbo Axis Induced by Unsteady Aerodynamic Force on Rotor Blade

Spatio-temporal distribution of aerodynamic forces and their associated vortex drift patterns around a closed-box girder during torsional vortex-induced vibration

Influence of flexural-torsional couplings and rotational effects on vibration behaviour of tapered thin-walled anisotropic biconvex beam

Examination of Hydrodynamic Force Acting on A Circular Cylinder in Vortex-Induced Vibrations in Synchronization

Elimination of lock-in phenomenon in vortex-induced vibration by passive modal control

Nonlinear vibrations of a rotating pretwisted blade

Vibration Equation and Frequency Computation of an Aero-engine Rotor Blade

Distributed lock-in drives broadband vortex-induced vibrations of a long flexible cylinder in shear flow

VIBRATION CHARACTERISTICS OF SYSTEMS WITH MULTIPLE BLADES

The coupled bending-torsional dynamic behavior in the rotating machinery: modeling, simulation and experiment validation

External and internal coupling effects of rotor's bending and torsional vibrations under unbalances

Fluid and Structure Coupling Analysis on Frequency Locking of an Elastic Hydrofoil

Mechanism of vortex-induced vibration in two lock-in regions for truss girder sections