Abstract:This paper presents an experimental and an analytical investigation of the behavior of Reinforced Concrete (RC) beams strengthened in flexure by means of different combinations of externally bonded hybrid Glass and Carbon Fiber Reinforced Polymer (GFRP/CFRP) sheets. In order to obtain the mechanical properties of the hybrid sheets, multiple tensile coupon tests were conducted. In addition, an experimental program consisting of a control beam and four beams strengthened in flexure with GFRP, CFRP and hybrid FRP sheets was conducted. The series of the RC beams were tested under four point bending to study the flexural effectiveness of the proposed hybrid FRP sheets. The load–deflection response, strain readings at certain locations and associated failure modes of the tested specimens had been recorded. It is observed that the increase in the load capacity of the strengthened beams ranged from 30% to 98% of the un-strengthened control RC beam depending on the combination of the Carbon/Glass sheets. It was also observed that the ductility at failure loads of the beams strengthened with glass and hybrid sheets is higher than that with a single carbon sheet. Hence, the selection of the optimum combination of hybrid sheets can lead to a strengthening material which provides an improved ductility and strength in beam behavior. The load carrying capacity of the tested specimens was then predicted by the ACI 440.2R-08 guidelines. The predicted and measured results were in good agreement, within 5% for the control beam and for beams with one layer of strengthening sheet and between 13% and 17% for beams with two or more layers of hybrid strengthening sheets. Furthermore, an analytical model was developed to predict the load–deflection response of the tested specimens and the results were compared with the measured experimental data. The results showed that the developed analytical model predicted the response of the tested beam specimens with reasonable accuracy.

The Response of Reinforced Concrete Composite Beams Reinforced with Pultruded GFRP to Repeated Loads

Impact Behavior of Composite Reinforced Concrete Beams with Pultruded I-GFRP Beam

Impact Testing of Reinforced Concrete Beams Shear-Strengthened with Fiber-Reinforced Polymer Wraps

Tests for anti-shear failure mechanism of CFRP-strengthened RC Beams without Stirrups under impact loading

Structural response of high strength concrete beams using fiber reinforced polymers under reversed cyclic loading

Theoretical Analysis of Composite RC Beams with Pultruded GFRP Beams subjected to Impact Loading

Fatigue Performance of Prefabricated Composite T‐beams under Cyclic Overloading: an Experimental Study

Analysis of concrete beams reinforced by GFRP bars with varying parameters

Effect of sustaining load level on flexural behavior of RC beams retrofitted with CFRP sheets

Low cycle fatigue crack propagation and damage evolution of concrete beams reinforced with GFRP bar

GFRP-concrete hybrid beams under flexural loading: Experimental investigation

Flexural Performance of Concrete Beams Reinforced with Continuous FRP Bars and Discrete Steel Fibers under Cyclic Loads

Shear performance of GFRP reinforced UHPC short beams

Experimental investigation on the behavior of fly-ash based geopolymer reinforced concrete beams strengthened with CFRP

Behavior of reinforced concrete beams strengthened with externally bonded hybrid fiber reinforced polymer systems

Flexural Response of Concrete Beams Reinforced with Steel and Fiber Reinforced Polymers

Numerical Response of Concrete-Filled Steel Tubular (CFST) Columns Externally Strengthened with FRP Composites Subjected to Cyclic Loading

Experimental investigation on shear behavior of GFRP-concrete hybrid beams

Flexural Behaviour of Hybrid Bar Reinforced Concrete Beams (GFRP Bars with Steel Wires): An Experimental Study

Load-Bearing Performance of Non-Prismatic RC Beams Wrapped with Carbon FRP Composites

Behavior of non-prismatic RC beams with conventional steel and green GFRP rebars for sustainable infrastructure