Abstract:Fiber hybridization is a new and effective way of altering the inherent low mechanical properties and durability issues of recycled concrete by using a multi-fiber approach. Research conducted thus far is majorly focused on studying the effects of hybrid fibers on the basic mechanical properties of recycled concrete and no attention is given to the multicriteria-based performance assessment, which is highly important from the perspective of practical applications. The current study is an effort in this regard that intends to evaluate, compare, and rate the multicriteria-based performance of a total of eleven mix formulations prepared with a single and hybrid usage of basalt fiber (BF), polypropylene fiber (PPF) and glass fiber (GF). In addition, two mineral admixtures namely pulverized flyash (PFA) and ground granulated blast furnace slag (GGBFS) were used. From the results of mechanical properties, it is determined that mix formulations comprising hybrid 0.75 %BF-0.25 %PPF and 0.5 %BF-0.5 %GF had the highest strength improvement of 16–21% in compressive strength, 36–49% in splitting tensile strength, and 54–71% in flexural strength. The freeze–thaw assessment revealed that the use of hybrid fibers together with PFA and GGBFS resulted in superior durability performance of recycled concrete specifically in terms of lower length variation (0.055%), lower mass loss (0.39%) and higher UPV (4137 m/s) after 300 cycles. From the cost analysis, it is observed that MRC-1BF had the highest net cost increase of 121.7% of all mixes. Lastly, the multicriteria analysis revealed that the hybrid BF-GF and BF-PPF based MRC had the best performance score and ranking of all formulations, thus implying that their practical use would be highly beneficial in terms of mechanical performance as well as cost-effectiveness.

Evaluation of performance of hybrid fiber-reinforced self-compacting concrete using non-destructive testing techniques

Mechanical performance, water and chloride permeability of hybrid steel-polypropylene fiber-reinforced recycled aggregate concrete

Strength and Permeability Evaluation of hybrid steel –basalt fibres reinforced concrete

Performance Evaluation of Hybrid Fiber Reinforced Concrete on Engineering Properties and Life cycle assessment: A sustainable approach

Self-consolidating hybrid fiber reinforced concrete: Development, properties and composite behavior

The Effect of Low Velocity Impact Loading on Self-Compacting Concrete Reinforced with Carbon Fiber Reinforced Polymers

Performance evaluation of indented macro synthetic polypropylene fibers in high strength self-compacting concrete (SCC)

Rheological properties of self compacting concrete with partial replacement of metakaolin in cement and plastic fibre

Influence of Polypropylene and Steel Fibers on the Performance and Crack Repair of Self-Compacting Concrete

Hybrid Effect Evaluation of Steel Fiber and Carbon Fiber on the Performance of the Fiber Reinforced Concrete.

Workability and mechanical behavior of steel fiber reinforced self-compacting concrete with supplementary cementitious materials

Multicriteria performance assessment of sustainable recycled concrete produced via hybrid usage of basalt, polypropylene and glass fiber

The effect of polypropylene fibres on the compressive strength, impact and heat resistance of self-compacting concrete

Mechanical performance and numerical simulation of high-performance steel fiber reinforced concrete

Experimental Investigation on the Mechanical Properties of Polypropylene Hybrid Fiber-Reinforced Roller-Compacted Concrete Pavements

Experimental Study on Hybrid Effect Evaluation of Fiber Reinforced Concrete Subjected to Drop Weight Impacts.

Investigating the properties of ternary-blended self-compacting concrete with fibre

Ultra-high performance of eco-friendly self-compacting concrete incorporated cement Kiln dust with/without waste plastic and polypropylene fiber

Mechanical performance evaluation of steel fiber-reinforced concrete (FRC) based on multi-mechanical indicators from split hopkinson pressure bar (SHPB) test

Performance of Hybrid Fiber Reinforced Concrete with Steel Fibers and Polypropylene Fibers

Feasibility of Recycled Carbon Fiber-Reinforced Polymer Fibers in Cementitious Composites: An Experimental Investigation