Abstract:Mechanical analysis and optimal design of down-hole tubular strings with connectors are the key theoretical bases of design and operation in extended-reach and horizontal drilling and completion. However, the complex mechanical interaction between spring connectors and open wellbores are not fully considered in conventional tubular models and the conventional design methods are mostly based on experience and lack of rigorous mathematical derivations. To overcome these shortcomings, a new revised mechanical model and an optimal design method of connectors on down-hole tubular strings have been built. Firstly, the local loads on a unified connector which can depict common spring and rigid connectors constrained in open wellbores are studied. The local connector loads are further introduced into the local mechanical model of tubular strings. The integral mechanical model of tubular strings is amended by the local model. Next, the integral design model of connectors while considering friction reduction, tubular centricity and cost is built. The integral design model is divided into a series of local design models according to the properties of tubular mechanical behaviors on extended-reach and horizontal wellbores. At last, the mechanical model and design method are applied to drill strings with joints and casing strings with centralizers in horizontal drilling and completion. The results indicate that the revised tubular mechanical model and connector design model are stable and fast. The coupling effects of connector and buckling, local drags on connector and radial compression of spring connectors are all included in the mechanical model, so the new model gives a more sophisticated description of mechanical behaviors of tubular strings with connectors. The design results of anti-drag joints are closely related to the clean condition of wellbores. Proper optimal design of connectors and good clean condition of wellbores can inhibit helical buckling, decrease friction factor and reduce plough effect, leading to larger lateral extending limits. Compared with the initial design results of centralizers, friction force is decreased and casing centricity is increased through optimization design. The optimization results of centralizers are closely related to the weight values of friction reduction, casing centricity and cost. Therefore, the key problem is how to assign these three weight values under actual engineering conditions.

Mechanical characteristics of a threaded joint of coring tool under makeup torque

Rock-Breaking Mechanism Study of Axial and Torsional Impact Hammer and Its Application in Deep Wells

DIC/DSI Based Studies on the Local Mechanical Behaviors of HR3C/T92 Dissimilar Welded Joint During Plastic Deformation

Experimental investigation of mechanical behavior of grade 8.8 and 10.9 small-sized (m14-m20) bolts with the thread into the bolt hole

Shear behavior of two-order morphology in rock joints

Research on Control Method for Machining Non-Cylinder Pin Hole of Piston

Analysis of secondary makeup characteristics of drill collar joint and prediction of downhole equivalent impact torque of Well SDTK1

Development Of Coring System With In-Situ Condition For Deep Rock By Ultrasonic

A special thread design for failure prevention of expandable casing

Nonlinear Analysis of the Threaded Connection with Three-Dimensional Finite Element Model

Numerical analyses of the influences of rock properties and joints on rock fragmentation in shaft sinking by drilling method

Experimental and Numerical Studies on Mechanical Characteristics and Fracture Behaviours of Jointed Rock with Different Roughness

An experimental investigation into the borehole drilling and strata characteristics

Drilling Process Monitoring for Predicting Mechanical Properties of Jointed Rock Mass: A Review

Measurement while core drilling based on a small-scale drilling platform: Mechanical and energy analysis

A novel thread connection structure of slimehole drilling tool in ultra-deep natural gas well

Effect of interference magnitude on ultimate strength and failure analysis of aluminium-drill-pipe-body-tool-joint-assemblies with Johnson-Cook model

Mechanical failure analysis during direct shear of double-joint rock mass

Mechanical Model and Optimal Design Method of Tubular Strings with Connectors Constrained in Extended-Reach and Horizontal Wells

Effect of joint microcharacteristics on macroshear behavior of single-bolted rock joints by the numerical modelling with PFC

Mechanical and fracture characteristics of single tunnel under the induced effect of a key joint