Abstract:The increase of the consumption of gypsum products in construction industry with a limited amount of natural gypsum deposits requires alternative sources of gypsum-containing raw materials. In some countries which have fertilizers industry plants, the problem can be solved using industrial wastes, e.g. phosphorgypsum – a byproduct of fertilizers’ production. Kept in dumps over decades, phosphorgypsum is subjected to the chemical changes due to washing out impurities with rain and other natural factors. However, there are observed deviations of harmful impurities in dumped PG depending on its age., Phosphorgypsum of any age requires chemical treatment to neutralize remains of phosphorus and sulfuric acids, fluorine compounds. According to our researches one of the most simple and effective method of neutralization the impurities is using lime-containing admixtures. The paper presents results of laboratory tests of phosphorgypsum as a component of clinker and non-clinker binders. There were investigated the impact of phosphorgypsum as admixture for clinker binders to substitute natural gypsum. Neutralized phosphorgypsum can be applied as mineralizing admixture in calcination of Portland cement clinker. Adding 2 to 2.5% of phosphorgypsum as setting time regulator resulted in a similar physical and mechanical properties compared to mix made with natural gypsum. Another important area of phosphorgypsum application is sulphate activatoion of low-clinker blast-furnace slag cement (clinker content is less than 19%). According to results, the incorporation of phosphorgypsum as sulphate activator in cement has the better effect as natural gypsum. Other development has been carried out to modify the phosphorgypsum binder properties. Complex additive consisted of polycarboxylate-based superplasticizer and slaked lime permitted an increase mechanical properties of hardened phosphorgypsum binder due to significant a reduction of water consumption. Such modified binder can be used as partial or complete replacement of gypsum binder for filling cements and finishing plasters. It can substitute gypsum in non-clinker binders like supersulphated cements. There were also developed compositions of supersulphated cements based on low-alumina blast furnace slag and phosphorgypsum. Supersulphated cements were tested in normal-weight and light-weight concrete.

Binders for pressed products based on phosphogypsum waste

The workability kinetics of phosphogypsum binder

Application areas of phosphogypsum in production of mineral binders and composites based on them: a review of research results

Effect of water-binder ratio on properties of phosphogypsum binder

Cementitious binder of phosphogypsum and other materials

Valorization of phosphogypsum as hydraulic binder

Geotechnical properties of hemihydrate and dihydrate phosphogypsum

Properties of Foamed Lightweight High-Performance Phosphogypsum-Based Ternary System Binder

Effect of multiphasic structure of binder particles on the mechanical properties of a gypsum-based material

Study on physical and chemical characteristics of β-hemihydrate phosphogypsum

High-strength gypsum binder with improved water-resistance coefficient derived from industrial wastes

Enhancement of phosphogypsum mechanical block with the addition of iron and aluminum salts

A Sustainable Composite Cementitious Material Manufactured by Phosphogypsum Waste

New dawn of solid waste resource treatment: Preparation of high-performance building materials from waste-gypsum by mechanical technology

Physical properties, strength, and impurities stability of phosphogypsum-based cold-bonded aggregates

MECHANICAL PROPERTIES OF PHOSPHOGYPSUM AND TRENDS ITS UTILIZATION

Utilization of phosphogypsum as raw and calcined material in manufacturing of building products

Investigation on a New Hydraulic Cementitious Binder Made from Phosphogypsum

High-quality gypsum binders based on synthetic calcium sulfate dihydrate produced from industrial waste