Corrosion and cavitation erosion behaviors of laser clad FeNiCoCr high-entropy alloy coatings with different types of TiC reinforcement
H. Wu,L. Wang,S. Zhang,C.L. Wu,C.H. Zhang,X.Y. Sun
DOI: https://doi.org/10.1016/j.surfcoat.2023.129910
IF: 4.865
2023-08-12
Surface and Coatings Technology
Abstract:By using laser cladding (LC), high entropy alloy coatings (HEACs) with FeNiCoCr as the base material and TiC added directly (D-TiC) and in-situ (I-TiC) were created. The phase composition, microstructure, mechanical characteristics, electrochemical corrosion, and cavitation erosion behavior of HEACs were examined in relation to two TiC addition methods, and a thorough investigation of the effects of mechanical characteristics and corrosion resistance on cavitation erosion behavior was conducted. Large clusters of TiC were visible in the D-TiC HEAC, in contrast to the sparse and scattered distribution of them in the I-TiC HEAC. The average grain size of the composite coating substantially fall from 25.7 μm for FeNiCoCr coating to 11.8 μm for D-TiC coating and 9.4 μm for I-TiC coating when TiC were included in the skeleton. The I-TiC composite coating precipitated by nucleation and growth with the maximum average microhardness of 440 ± 6 HV under the combined action of solid solution strengthening, fine crystal strengthening, and second phase strengthening. In 3.5 wt% NaCl solution, the galvanic corrosion between TiC particles and the FCC matrix significantly weakened the corrosion resistance of the D-TiC HEAC, with the I corr reaching 3.47 × 10 −2 ± 0.8 μA/cm 2 . The I-TiC HEAC exhibited approximately equal corrosion resistance to FeNiCoCr with an I corr of merely 5.92 × 10 −3 ± 0.3 μA/cm 2 . Varying cavitation incubation periods (IPs) existed in 316 SS and HEACs at the beginning of the cavitation experiment. The mean depth of erosion rate (MDER) of FeNiCoCr, D-TiC and I-TiC coatings was 0.19 ± 0.09, 0.42 ± 0.04, and 0.15 ± 0.02 μm h −1 , respectively, which was only 1/5, 1/2, and 1/6 of that of substrate (0.90 ± 0.13 μm h −1 ). The cavitation surface of 316 SS was full of craters and cracks without any original surface. Meanwhile, due to the weak interfacial bonding strength between TiC/HEA, the cavitation erosion morphologies of D-TiC HEAC contained spallation of large TiC particles. Attributed to its ideal mechanical and corrosion resistance, the I-TiC composite coating demonstrated the best resistance to cavitation erosion.
physics, applied,materials science, coatings & films